Drill, Ream... Portfolio Page
1
James Manning Drill, Ream, Counterbore, Countersink, and Requirements: 1. 1/4 “ Reamed hole 2. Counterbore a clearance hole for a 3/8-16 SHCS 3. Countersink a clearance hole for a ¼-20 FHMS 4. Tap a ¼-20 x ½” deep thread, Clearance drill back side to ½” depth 5. Chamfer a 45 degree angle on the bottom Chamfered edges Tapped, Deep Threaded and machined a half inch back into block Counterbo re, Drilled & tapped Counters ink, Drilled & Reamed Materials Used: • 3” x 3” x 1” steel block • Manual Mill • Manual Lathe
-
Upload
james-manning -
Category
Documents
-
view
60 -
download
0
Transcript of Drill, Ream... Portfolio Page
James ManningDrill, Ream, Counterbore,
Countersink, and Tap
Requirements:1. 1/4 “ Reamed hole2. Counterbore a clearance hole for a
3/8-16 SHCS3. Countersink a clearance hole for a ¼-
20 FHMS4. Tap a ¼-20 x ½” deep thread,
Clearance drill back side to ½” depth5. Chamfer a 45 degree angle on the
bottom
Chamfered edges Tapped, Deep Threaded and machined a half inch back into block
Counterbore,Drilled & tapped
Countersink,Drilled & Reamed Materials Used:
• 3” x 3” x 1” steel block• Manual Mill• Manual Lathe