DIY Installation
-
Upload
platform81 -
Category
Documents
-
view
248 -
download
2
description
Transcript of DIY Installation
• Rolls of artificial grass can be heavy. Please take care when lifting and handling!
• Do not lay artificial grass in areas liable to flooding.
• Heavily weeded areas should be treated with weedkiller before laying grass.
• The products to which this guide applies do not need rubber or sand brushing in.
• Maintenance required only removal of leaves and twigs etc with a soft brush or blower. Dog/animal mess use mild detergent and water.
Equipment
sharp craft knife
hammeradhesive spreader
wheelbarrow
straight edge for sand
shovel
For ease
motorised turf remover motorised plate compactor
Available from hire shops
no mud no mess no mowing
Effortlessly beautiful ARTIFICIAL GRASS
a r t i f i c i a l g r a s s
need advice?
visit www.artificialgrassdiy.com
artificial grass guide
How to install
for product & fitting information, previous installation & FAQ’s
need advice?
visit www.artificialgrassdiy.comfor product & fitting information, previous installation & FAQ’s
• instant beautiful lawn
• looks like real grass
• feels like real grass
• tough and hardwearing
Easy to installOrder in-store nowFree home delivery
a r t i f i c i a l g r a s s
www.nomow.co.uk
Nomow Ltd. Hallsteads Business Park, Dove Holes, Buxton, Derbyshire, SK17 8BJ UK
Strip turf, removing all the grass down by an average thickness of 40mm. This can be done using a spade.
1
35mm
1
2
35mm
1
Roll out grass to cover areas. Trim edges of grass rolls using a craft knife
5 It’s always easier to cut the grass rolls from underneath
Loose jointed. 3mm gap
• Apply adhesive onto jointing tape (rough side up) and spread along join surface.
• Place roll edge onto tape making sure the fibres do not touch the glue.
• Ruffle up the pile at the joint to disguise
Edge fixing
• To fix down the edges, use the ground pins and fix through grass at 200mm intervals.
• Ruffle the grass over the pin heads to disguise.
7
Angle pins to avoid lifting
If fitting on a solid surface such as concrete or tarmac use a bead of adhesive along all edges.
6 If jointing is required
8 Stand back and enjoy!
Spread and level and compact 35mm of sharp builders sand.
• If jointing ensure grass rolls are butted together with no fibres caught underneath.
• Ensure all grass rolls are laid in the same direction so the blades of grass point the same way.
Compact sand using a builders plank & heavy hammer
Re-smooth sand after completion. Gentle slopes or mounds are fine.
3
35mm
1
4
35mm
1
35mm
1
300mm overlap
Using a mechanical turf lifter * makes light work.
* Available from hire shops
Using a compaction plate * makes light work.
*Available from hire shops
Over the top of the sand roll out weed membrane, overlapping joints by 300mm. Leaving it 50mm short of the grass edge.