Digital Patternsstevedgood.com/skullwall.pdf1/2” Thick Skull. 1/2” Thick 1/4” Thick Paint...
Transcript of Digital Patternsstevedgood.com/skullwall.pdf1/2” Thick Skull. 1/2” Thick 1/4” Thick Paint...
Designed by Steve GoodDigital Patterns
Hundreds of free PatternsStencil PrinterJigsaw Puzzle TemplatesDVD’sKey Chain Pattern PrinterVideo TutorialsReviewsCommunity Forum and more.
If you would liketo donate click
here. No Paypalaccount needed.
Note to commercial print employees: I give my permission to print as many of this pattern book as your customer requires.
[email protected] Copyright Steve Good 2017
Note to commercial print employees: I give my permission to print as many of this pattern book as your customer requires.
[email protected] Copyright Steve Good 2019
General Pattern InformationYou may use this pattern to make as many of the project as you like. You are free to use any technique including mass production to build the project. The pattern may be copied and
given to others provided the entire book is kept intact. You may not sell the pattern or include it
in another commercial package of any type.
Steve Good retains the right to the pattern. If you have any questions about the use of this
pattern please contact me at [email protected]
Printing InstructionsWhen printing this pattern it is important to print it full size. When you bring up the print dialog
box look in the “Page Sizing & Handling” section. Make sure the “Actual Size” is selected
before you hit print.
You also only need to print the page/s you need. After the print dialog opens look for the
“Pages to Print” section. You can print the current page or a range of pages. This will help
save ink by not printing the title/instruction pages.
Skeleton coming out of the wall.
Tape the hole board pattern together for a full size pattern.Glue the pattern to the hole board.
Mask off 1/4” of the backer board for later glue area.Paint the backer board black.
Cut the remaining parts.
Mask off a few areas on the skull backer board forgluing.
Paint the skull backer board black.
Remove the masking tape from the skull backer board.Glue the skull backer board the the back of the skull.
1
2
3
4
5
2
3
Glue the spine bone(1) to the backer board in the position shown.Glue the wrist bones(2) to the hand bones(3)
Pay attention to the orientation of the wrist bonesIMPORTANT:to the hand bones. When completed the thumbs should be
pointed in like the picture below
I used a sawtooth hanger on the back.
1/2” Thick
Skull
1/2” Thick
1/4” Thick Paint Black
Skull Backer
Spine Bone
1/2” Thick
Wrist Bone
Wrist Bone
Hand Bones
Hand Bones
1/2” ThickLeft
Hole
Wrist bone goes here
Right
Wrist bone goes here
Cut a backer board 10” X 10” X 1/4”Paint the backer board black.
Not full size.
Cut 10” X 10” X 1/4”