DESMI priming ejector.pdf
-
Upload
esvaran-keshev-rao -
Category
Documents
-
view
168 -
download
2
description
Transcript of DESMI priming ejector.pdf
Function:Compressed air will flow through the ejector D andcreate a vacuum in the pump casing and suction line. After priming, the pumps will build up pres-sure in the discharge line which will activate the presure switch F . The presssure switch then dis-connect the power to the solenoid valves E and the priming stops automati-cally.
At a fluid pressure of e.g. 10 m total head the unit will disconnect automati-cally (adjustable from 3 - 100 m total head). If the pressure drops to less than 10 m total head the unit will automatically start functioning until a counter pressure has been reestablished.
DESMI priming ejector
DESMI Danmark A/STagholm 1DK-9400 NørresundbyPhone: + 45 72 44 02 50Fax: + 45 98 17 54 99Internet: www.desmi.dkE-mail: [email protected]
The DESMI priming ejector is designed for mounting on non-selfpriming centrifu-gal pumps thus making the pump unit self-priming.
In order to make the unit work, the delivery pipe has to be shut off, e.g. by means of a non-return valve
A Drain
B Air Inlet
C Check valve
D Ejector
E Solenoid valve
F Pressure switch
G Connection with suction line
D
E
A
F
C
B E
G
DESMI A/STagholm 1DK-9400 NørresundbyPhone: + 45 96 32 81 11Fax: + 45 98 17 54 99Internet: www.desmi.comE-mail: [email protected]
- contact us for further information
The DESM priming ejec-tor is available in sizes 1/2” or 1”. Ejectors can be supplied with one or two solenoid valves. Depend-ing on the specific task.