1. MAKE ALL LETTERING , NUMBERS AND ARROWS IN RED.

2. USE ARIAL FONT CHARACTERS.

4. ARROWS MUST BE .50 STROKE

5. LETTERING MUST BE 8 PT TO 10 PT

6. ALL LETTERING MUST BE CAPTTALIZED

7. ARROWS MUST POINT TO POINT TO EXACTLY WHAT YOU ARE EXPLAINING.

8. TRY TO USE ABBREVIATIONS WHERE POSSIBLE TO LIMIT OVERCROWDING IN TECH PAK.

9. DETAIL ALL STITCHING, TRIMS, SPECS NEEDED. ONLY PUT SPECS THAT ARE NOT IN SPEC SHEET LIKE BELT LOOPS, POCKET SIZES, PLACEMENT SPECS ETC.

10. MAKE ALL SKETCHES AND DETAILS AS LARGE AS POSSIBLE ON THE SKETCH PAGE.

11. SKETCH GARMENT EXACTLY AS ORIGINAL GARMENT AND SKETCH AS IF THEY WERE PATTERNPIECES NOT FLOWING BUT FLAT. DO NOT ADD EXTRA LINES OR GATHERS THAN NEEDED.

12. MAKE ALL INFORMATION LEGIBLE A EASY TO READ AND UNDERSTAND , DO NOT OVERCROWOR PUT TOO MANY ARROWS OR INFO THAN NEEDED.

CALLING OUT AND DETAILING A TECHNICAL SKETCH PAGE