Datasheet HA-CMK-01
-
Upload
jamal-hagi -
Category
Documents
-
view
216 -
download
0
Transcript of Datasheet HA-CMK-01
-
7/28/2019 Datasheet HA-CMK-01
1/2
Product Data Sheet HA-CMK-01
HYBRIFLEX Cable Management Kit
RFS The Clear Choice
HA-CMK-01 Rev: Preliminary / 23. May 2013 Print Date: 23 May 2013
Please Visit Us on the internet at http://wwwrfsworld.com Radio Frequency Systems
Allinformationcontainedinthepresentdatasheetissubject
toconfirmationattimeofordering
Product description
RFS' HYBRIFLEXCable Management Kit HA-CMK-01 is applicable to fix the cables on a pre-assembled Sector-Support withHUAWEI, ZTE and E/// RRUs
HA-CMK-01 contains all necessary piece parts to fix all RF-Jumper, HYBRIFLEX Jumper and grounding cables. A groundingbus bar is also included.
Disclaimer:The function, especially regarding the grounding, of this kit depends on the quality of the installationAll local rules and regulations have to be observed during installation
Features Benefits Overview
Easy to install RSB clips with round member adapter
Allows fast and flexible installation of cable clamps to the Sector-Support (pole) Flexible Positioning
The combination of RSB clips with roundmember adapter gives a big degree of freedom howand where to place the clamps. It can be installed in each position of the pole, the pole diametercan vary from 80mm to 100mm and even the clamps itself can be slightly tilted to allow asmooth cable run
Easy cable management with three layers of fixing points Layer 1 at the bottom of the Sector-Support (above the distribution box) Layer 2 between distribution box and lower RRU-Bracket Layer 3 between lower RRU and upper RRU-Bracket
Grounding Bus Bar The common bus bar allows pre-termination of grounding of all components (antenna,RRUs, distribution box) to one central point, where the whole Sector-Support can be connectedto the tower grounding system
C
ContentsItem* Quantity
Stainless steel cable hanger, diameter 30 pcs.
Stainless steel round member adapter, 5 7diameter 5 pcs.
Grounding bus bar, 8 terminals, 2,5 25mm 1 pc.
Grounding wire 16mm 15m
Cable lug, 16mm, one hole 10,2mm diameter, crimp on 5 pcs
Adhesive heat shrink tube, 32mm length 5 pcs
EPDM rubber cushion 10 pcs.Pipe diameter extender cushion 8 pcs
WPFG-1, Weather proof kit 1 pc.*) all plastic and rubber parts except butyl rubber tape of weatherproofing kit are UV-resistant
Details
Grounding bus bar
Fixing of groundingwire
The grounding wirewill be guided bythe rubber cushionin the bottom areaof the hanger.
Distribution BoxGrounding bus bar
Layer 212x hangerLayer 112x hanger
Layer 36x hanger
-
7/28/2019 Datasheet HA-CMK-01
2/2
Product Data Sheet HA-CMK-01
HYBRIFLEX Cable Management Kit
RFS The Clear Choice
HA-CMK-01 Rev: Preliminary / 23. May 2013 Print Date: 23 May 2013
Please Visit Us on the internet at http://wwwrfsworld.com Radio Frequency Systems
Grounding bus barfixed to the SectorSupport
Grounding bus barat the bottom of apole
Overview
Packing- All items in carton box
Pipe diameterextension