DATA SHEET

EMI GAGE 28W144 Industrial Ave Suite # 100 Lake Barrington, IL 60010-5939 Tel: (847) 277-7511 Fax: (847) 277-7911

Measurement Capacity

Maximum Diameter 406mm (16in)

Maximum Weight 45Kg (100lb)

Maximum Height 432mm (17in)

Gage Post and Arm Vertical Travel 370mm (14.5in)

Worktable & Spindle

Bearing Hardened Stainless Steel Air Bearing

Worktable Diameter 150mm (6in)

Speed of Rotation 6/10 rpm nominal, clockwise

Range of Centring ± 2.54mm (± 0.100in)

Range of Levelling ± 1˚ Roundness Limit of Error

(departure from Least Squares Circle at 6 rpm with 0-50 upr

filter)

Concentric Load within 0.25µm + 0.0003µm/mm height above worktable (10 µin + 0.8 µin/inch)*

Axial Error 0.25µm (10 µin) maximum axial movement of worktable during one revolution

Gauge (Adj. Pivot Lever Type) Gaging Force 0.18oz (5g), bi-directional

Range of Gage Movement ± 0.25mm (0.010in)

Fine Adjust Range 6.35mm (0.250in)

Probe length 32mm(1.25in) Standard

Utilities

Operating Pressure 30-60psig(2-5kgf/cm2)

Filter/Regulator 5micron built onto base module

Air Consumption 1.2 scfm (.034m3/m)@60psig 5kgf/cm2

Power Remote 40watt switcher, 100-240 VAC, 50-60Hz, +5vdc, 12vdc output

Software

Filter 0-15, 0-50,0-150, 0-500 UPR

Reference Circles LSC,MRS, MIC, MCC (ANSI B89.3.1 – 1972/1988)

TrueRond Roundness Software for Windows™ operating system

Roundness, Eccentricity, Ecc. Angle, Concentricity, Circular Runout, Sector Roundness, Flatness, Squareness, Squareness Angle, Planar Runout

PRECITECH FMS 8150(PC)

ROUNDNESS MEASUREMENT WINDOWS™ BASED SOFTWARE AFFORDABLE PRICE AIR BEARING SPINDLE IMMEDIATE DELIVERY

INCLUDES: PC, MONITOR, CONTROLLER, GAGE AND 3-JAW CHUCK!

The FMS 8150 Form Measurement System measures out-of-roundness, eccentricity, FIM, squareness, circular flatness and parallelism of continuous and partial arc surfaces. The high accuracy rotary table consists of a hardened stainless steel worktable mounted on a spindle that is supported by a radial and axial bearing. The worktable is lapped flat and has centering grooves and tapped fixturing holes. The pivot lever gage features a clutched stylus that can swivel through a 200˚ arc to facilitate instrument setup. Control knobs allow convenient adjustment of stylus fine position, gaging force and gaging direction. The gage and post arm assembly features conveniently located directional control knobs for ease of horizontal and vertical positioning of the gage head. The horizontal arm swing accepts parts up to 450mm (16in) in diameter. The dual gage head swivel feature at the end of the horizontal arm allows flexible positioning for virtually any requirement. The gage is complimented with an Interface Electronics Controller (IEC) that has connections for dual gage heads as well as USB and serial port. The accompanying PC utilizes Windows™ based TrueRond software for all measurements and results information.