DAMODAR VALLEY CORPORATION(THERMAL POWER STATION),DURGAPUR seminar
-
Upload
student-of-btech-in-electrical-engineering -
Category
Presentations & Public Speaking
-
view
416 -
download
9
description
Transcript of DAMODAR VALLEY CORPORATION(THERMAL POWER STATION),DURGAPUR seminar
NAME:-Udit Narayan Das
ROLL NO.:- 11901611109
A thermal power station is a power plant in which the prime mover is steam driven.
It works on the RANKINE CYCLE.
Damodar Valley Corporation (DVC) was established in 1948 under an Act of Parliament for unified development of Damodar Valley covering an area of 24,235 sq km in Bihar and West Bengal.
DURGAPUR STEEL THERMAL POWER STATION is a Thermal Power Project of Damodar Valley Corporation (DVC) whose construction, commissioning activity is undertaken by Bharat Heavy Electricals Limited (BHEL).
Coal conveyor
Stoker
Pulveriser
Boiler
Coal ash
Air pre-heater
Electrostatic precipitator
Smoke stack
Turbine
Condenser
Transformers
Cooling towers
Generator
Power House
High voltage power lines
Coal handling plant
Main generating plant
Ash handling plant
Switchyard
CHP handles the coal from its receipt to transferring it to bunkers.
Wagon tipplers are used to unload the coal into underground conveyer belts from where they are transported to penthouse where suspended magnets are used to detect metals.
Crushers are used to crush the coal into small pieces which are then transported to coal storage via coal conveyer.
When the coal is to be used Pulverizer is used to grind the coal into dust.
Here, the burning of coal starts.
it contains various equipments which help in
generation of electric energy.
Pulverized coal is put
in boiler furnance
Boiler is an enclosed
vessel in which water
is heated and
circulated until the
water is turned in to
steam at the required
pressure.
Super-heater: Superheater is a component of a steam-generating unit in which steam, after it has left the boiler drum, is heated above its saturation temperature.
Reheater : Reheater is also steam boiler component in which heat is added to this intermediate-pressure steam, which has given up some of its energy in expansion through the high-pressure turbine.
Condenser : Condensers are heat exchangers which convert steam from its gaseous to its liquid state, also known as phase transition.
Cooling Towers: It is a tower- or building-like device in which atmospheric air (the heat receiver) circulates in direct or indirect contact with warmer water (the heat source) and the water is thereby cooled
Function of
economiser is to
recover some of the
heat from the heat
carried away in the
flue gases up the
chimney and utilize
for heating the feed
water to the boiler.
Air preheater : It is a
device used in steam
boilers to transfer heat
from the flue gases to the
combustion air before the
air enters the furnace.
Smoke stack : A chimney
is a system for venting hot
flue gases or smoke from a
boiler, stove, furnace or
fireplace to the outside
atmosphere.
Extracts thermal energy from pressurized steam and uses it to do mechanical work on a rotating output shaft.
uses multiple stages in the expansion of the steam.
Converts mechanical energy into electrical energy.
Turbine is coupled with the Turbo generator that normally spins at 3000 rpm in countries with 50 Hz supply frequency
The generated voltage is stepped up in Generator Transformer and the power is evacuated through transmission line feeders.
The main operations are:
Removal of ash from furnace.
Transfer of ash to a fill or storage.
Disposal.
Ash can be disposed of as:
Dry ash system
Ash slurry system
It is a device which removes dust or other finely divided particles from flue gases by charging the particles inductively with an electric field, then attracting them to highly charged collector plates.
Hub of electrical power sources.
Exists in a generating station to coordinate the transfer of power between generators and transmission lines.
It contains current carrying conductors, transformers, circuit breakers etc.
As the population is increasing, the
consumption of power is also increasing.
In order to meet the needs of future
generation, power should be used efficiently.