Serial interfacesSPI:

The Nand Logic SPI module is compatable with the industry standard specification.

I2C:Our I2C module is compatable with the industry stand I2C specification. It has versitaility and unique configurations that allow it to communicate with a variety different of slave devices on a transaction by transaction basis. USB FX-Interface:The Nand Logic USB-FX2 interface is compatible with the cypress EZUSB-FX2 interface. The module is designed with some autonomous capabilities.

UART:The Nand Logic UART offers RS-232 industry standard communication controls and it operates according the protocol specification. If offers unique customizations as well

Memory ControllersSRAM Controller:

The Nand Logic SRAM controller provides can control up to 8 SRAM devices. Control of each device can be handled independently of each other

Flash Controller:The Nand Logic FLASH controller provides software programmable control and autonomous hardware control for industry standard FLASH devices.

DDR Controller:The Nand Logic DDR controller supports industry standard DDR memory devices of size 8, 16 and 32 bits. The controller provides a number of features which allow for quick access to data stored in the individual banks and rows.

Motor ControllerPulse Width Modulator:The Nand Logic PWM ICs are very flexible and provide 16bits of resolution for increased accuracy and control over electric motors, analog and digital servos. 

PWM-Encoders:The Nand Logic PWM-Encoders were designed as interface encoders the R/C transmitters and receivers. Our PWMEs digitally encode servo and motor control signal coming in off chip from receivers capturing wireless control signals from a radio device. Stepper Motor Controller:Stepper motors are motors which move in steps as a posed to conventional motors which move continuously.  Nand Logic's stepper motor controller IC is composed of an independent driver and control unit both of which are software programmable. The architecture of the controller abstracts away the low level control tasks from the programmer, allowing the programmer to program in a sequence of steps and actions to achieve a higher level function.

Custom SoCCustom SoCIn the industry, SoC is used to describe a generic IC composed of the all the components of a computer. At Nand Logic we more appropriately define our SoCs as a Single Chip Solution or SCS, we coin the phrase SCS to define an all in one digital system architected for a custom application.Single Core SoC:Nand Logic Single-Core SoCs are architected to maximize system throughput. We accomplish this in part by minimizing the latency between CPU instruction and peripheral response. Our round robin response time is less the 10 system clock cycles. In addition to this, our bus subsystem is pipelined, processing reads and rights in as few as three clock cycles each. Multi-Core SoC:Nand Logic Multi-Core SoCs have an asymmetrical architecture, the system is heterogeneous by design. Each of the respective cores and their Closely Coupled RAMs are independent of each other; therefore each core can handle separated sections of the embedded application. 

Derrick WashingtonPresident, Nand Logic CorporationAddress:7830 Royan DriveHouston, TX 77071Email: socnet@nandlogic.comPhone:(407) 476-3893

Contact us