CUT
description
Transcript of CUT
![Page 1: CUT](https://reader033.fdocuments.net/reader033/viewer/2022051821/568bd6151a28ab20349ac88e/html5/thumbnails/1.jpg)
ARCHITECTURE DESIGN STUDIO AIR
JOURNAL
DEGUO HOU (JACK)387313
![Page 2: CUT](https://reader033.fdocuments.net/reader033/viewer/2022051821/568bd6151a28ab20349ac88e/html5/thumbnails/2.jpg)
Boolean patterning combin with image sampler and Data driven rotation
Boolean patterning combin with im-age sampler and Data driven extruc-sion
![Page 3: CUT](https://reader033.fdocuments.net/reader033/viewer/2022051821/568bd6151a28ab20349ac88e/html5/thumbnails/3.jpg)
Explicit Grids combin with image sampler and preview
Surface Grids combin with image sampler and Data driven Extrucsion
![Page 4: CUT](https://reader033.fdocuments.net/reader033/viewer/2022051821/568bd6151a28ab20349ac88e/html5/thumbnails/4.jpg)
Boolean patterning combin with Attractor point and Data driven extrucsion
Surface Grids combin with Attractor point and Circle
![Page 5: CUT](https://reader033.fdocuments.net/reader033/viewer/2022051821/568bd6151a28ab20349ac88e/html5/thumbnails/5.jpg)
Arbitrary points combin with image sampler and Data driven Rotation
Boolean patterning combin with image sampler and Data driven Rotation
![Page 6: CUT](https://reader033.fdocuments.net/reader033/viewer/2022051821/568bd6151a28ab20349ac88e/html5/thumbnails/6.jpg)
Boolean patterning combin with image sam-pler and Data driven Rotation
Following the CUT definitions, I took some part of inpput out and combine with others, try to work out a complex and well-look model. What I found interstesting is the image samper, and the rotation and extruction. By combine all those different input, association and output togeter, now I get better knowledge about grasshooper, and quite enjoy it. However, most output I found are in a geomtric of circle, when I trying to build a rectangle or triangle, I found difficult to do that, and actually I’m faild. The last model looks quite simple, with this one, I tried to relate to our next proj-ect- Gateway, what I did is first create a surface and try to use CUT to create a bunch of small open-ings and then by using data driven rotation to rotate its direction to different ways, however, as I just mentioned earlier, I’m failed to do that as I cannot create a rectanangle and triangle in grasshooper. So with the circle output, this idea is not working very well.