Curtain Track - Instructions
1
CURTAIN TRACK INSTRUCTIONS Fasten the curtain track to the mounting brackets installed in step #2. To fasten, insert the curtain track into the two prongs of the bracket and push the other end in to snap the curtain track in place. Attach the curtain using the "J" hooks to the track rollers. Important: Refrain from using excessive force to snap the bracket into the curtain track. The curtain track is packaged coiled. Allow the curtain track to straighten for at least 24 hours prior to installation. To straighten and/or bend the curtain track, use heat (hair dryer or submerge in hot water) or place heavy objects along the track. If required, use a hacksaw to cut the curtain track to the desired length. Draw a line along the ceiling where the curtain is to be installed. Mount the ceiling brackets with the provided anchors (if into just drywall and not a stud) and screws approximately 12-14 inches apart. Leave 1 inch on each end to ensure the end cover can fit. Add additional brackets as needed where a sharp turn occurs. Insert the track rollers into the curtain track. The track roller wheels should roll on the inner track. Fasten the other track end cover in place to lock in the track rollers. 1 4 5 2 12"-14" Important: All lockable brackets must be facing the same direction. Fasten the track end cover on one end of the curtain track with the loop facing down. 3
Transcript of Curtain Track - Instructions
CURTAIN TRACK INSTRUCTIONS
Fasten the curtain track to the mounting brackets installedin step #2. To fasten, insert the curtain track into the twoprongs of the bracket and push the other end in to snap thecurtain track in place. Attach the curtain using the "J" hooksto the track rollers.
Important: Refrain from using excessive force to snap thebracket into the curtain track.
The curtain track is packaged coiled. Allow the curtain track tostraighten for at least 24 hours prior to installation. To straightenand/or bend the curtain track, use heat (hair dryer or submerge inhot water) or place heavy objects along the track.
If required, use a hacksaw to cut the curtain track to thedesired length.
Draw a line along the ceiling where thecurtain is to be installed. Mount theceiling brackets with the providedanchors (if into just drywall and not astud) and screws approximately 12-14inches apart. Leave 1 inch on each endto ensure the end cover can fit. Addadditional brackets as needed where asharp turn occurs.
Insert the track rollers intothe curtain track. The trackroller wheels should roll onthe inner track.
Fasten the other track endcover in place to lock in thetrack rollers.
FOR VIDEO INSTALLATION INSTRUCTIONS, VISIT: https://urbanred.co/trackinstall
1 4
5212"-14"
Important: All lockable brackets must be facing the same direction.
Fasten the track end cover on oneend of the curtain track with the loopfacing down.
3
