Cooling Tower Sprayer - Hewitech...The three-stage sprayer system optimize the spray zone of...
2
The three-stage sprayer system opmize the spray zone of hyperbolic or forced draſt cooling towers. The performance effect generate cooling immediately aſter water outlet of the pipe system and already above the fill media (spray zone) in order to get the maximum cooling performance of the tower. The various inserts, sealing and a special adapter grant that this spacers can be used in mulple cooling tower designs. Cooling Tower Sprayer High effecve water distribuon in cooling towers High efficiency of cooling processes begins with opmized water distribuon above the fill media. The mul-adapter for various pipe dimensions allows to adapt each installed distribuon system. Deliverable inserts opmize the given water pressure to an excellent water distribuon above first cooling fill layer. Design Diversity · Sustainable Efficiency · Custom-made Soluon www.hewitech.de Features: · Made of PP · Low fouling behavior · Adjustable water distribuon · Easy installaon in exisng pipe systems · High temperature and chemical resistant · Opmized spray zone effect maximizing cooling performance and beer cooling on the surface of installed fill media Sprayer System
Transcript of Cooling Tower Sprayer - Hewitech...The three-stage sprayer system optimize the spray zone of...
-
The three-stage sprayer system optimize the spray
zone of hyperbolic or forced draft cooling towers. The
performance effect generate cooling immediately after
water outlet of the pipe system and already above the
fill media (spray zone) in order to get the maximum
cooling performance of the tower.
The various inserts, sealing and a special adapter grant
that this spacers can be used in multiple cooling tower
designs.
Cooling Tower SprayerHigh effective water distribution in cooling towers
High efficiency of cooling processes begins with optimized water distribution above the fill media. The multi-adapter for various pipe dimensions allows to adapt each installed distribution system. Deliverable inserts optimize the given water pressure to an excellent water distribution above first cooling fill layer.
Design Diversity · Sustainable Efficiency · Custom-made Solutionwww.hewitech.de
Features:
· Made of PP
· Low fouling behavior
· Adjustable water distribution
· Easy installation in existing pipe systems
· High temperature and chemical resistant
· Optimized spray zone effect maximizing cooling
performance and better cooling on the surface of
installed fill media
Sprayer System
-
Sprayer Program
This general information about technical data and descriptions of our products has been put together with greatest care. We reserve the rights of any changes without further notice. We recommend to re-check data before using in final project designs. All data without obligations and consequences due to non-compliance.
HEWITECH sprayer program
Structure Code Material InsertsDiameter
[mm]Information
SprayerPP
(reinforced)
182224262830323436
Sprayer Set
Connector PP none Connector for pipes
Sealing
100160200250300350400500
Hewitech GmbH & Co KG - Am Langenhorster Bahnhof 16 - D-48607 Ochtrup/Germany +49 2553 97 02 60 · [email protected] · www.hewitech.de
Technical information· Material: Polypropylene (PP)
· Resistant to dissolved various chemicals, fungi and rot
resistant
· Maximal operation temperature: 75 °C (PP)
· Tolerances: max 2%
· On request special flame retardant to meet
ASTM E84 and DIN 4102 (other norms on request)
Wat
er F
low
rate
per
noz
zle
[m3 /
h]
Water Inlet Pressure [m]
Sprayer characteristic
20
18
16
14
12
10
8
6
4
2
00,4 0,6 0,8 1 1,2 1,4 1,6
Ø 34m
Ø 32m
Ø 29m
Ø 25m
Ø 24m
Ø 22m
