Configure Nokia E71WiFi SIP Client With the 3300

8/2/2019 Configure Nokia E71WiFi SIP Client With the 3300

1/14

How-To-GuideConfigure the Mitel 3300 ICP for use with the Nokia E71 Mobile

Phone

Document # 08-5159-00027 Page 1


2/14

About this document

This How-To-Guide is intended for Customer Service and Installation Personnel involved in theinstallation and maintenance of Mitel 3300 ICPs.

NOTICE

The information contained in this document is believed to be accurate in all respects but is not

warranted by Mitel Networks Corporation. The information is subjected to change without notice and

should not be construed in any way as a commitment by Mitel or any of its affiliates or subsidiaries.

Mitel and its affiliates and subsidiaries assume no responsibility for any errors or omissions in this

document. Revisions of this document or new editions of it may be issued to incorporate changes.

How-To-Guide configure the Mitel 3300 ICP for use with the Nokia E71 Mobile Phone

, Trademark of MITEL Networks Corporation

Copyright 2009, MITEL Networks Corporation

All rights reserved

Document # 08-5159-00027 Page 2


3/14

Table of Contents

Overview...................................................................................4

Software & Hardware Setup.......................................................4

Device Limitations.....................................................................4

3300 Setup Notes ......................................................................5

Network Requirements..............................................................................5

Assumptions for the 3300 ICP programming................................................5

Licensing and Option Selection - SIP Licensing............................................6

Multiline IP Set Configuration....................................................................7

Class of Service Assignment......................................................................8SIP Device Capabilities Assignment..........................................................10

Station Service Assignment.....................................................................11

Multiline Set Key Assignment...................................................................12

Nokia E71 Mobile Phone Setup Notes .......................................13

Document # 08-5159-00027 Page 3


4/14

Overview

This document provides a reference to Mitel Authorized Solutions providers for configuring the Mitel

3300 ICP to host the Nokia E71 Mobile Phone. The different devices can be configured in variousconfigurations depending on your VoIP solution. This document covers a basic setup with requiredoption setup.

Software & Hardware Setup

This was the test setup to generate a basic SIP call between the Nokia E71 Mobile Phone SIP deviceand the 3300 ICP.

Manufacturer Variant Software Version

Mitel 3300 ICP MXe platform 9.0.1.20

Nokia Nokia E71 Mobile Phone110.07.127 (09-10-

2008)

Device Limitations

This is a list of problems or not supported features when the Nokia E71 Mobile Phone is connected tothe Mitel 3300.

Feature Problem Description

MWI Nokia E71 does not support MWI

Conference Nokia E71 does not support device-based conference

Call Forwarding Nokia E71 does not support device-based call forwarding

Call hold There is no music played on Nokia E71

Teleworker Nokia does not register and thus does not work with Teleworker

Document # 08-5159-00027 Page 4


5/14

3300 Setup Notes

The following steps show how to program a 3300 ICP to connect with the Nokia E71 Mobile Phone.

Network Requirements

There must be adequate bandwidth to support the voice over IP. As a guide, the Ethernet

bandwidth is approx 85 Kb/s per G.711 voice session and 29 Kb/s per G.729 voice session

(assumes 20ms packetization). As an example, for 20 simultaneous SIP sessions, the Ethernet

bandwidth consumption will be approx 1.7 Mb/s for G.711 and 0.6Mb/s. Almost all Enterprise LAN

networks can support this level of traffic without any special engineering. Please refer to the 3300

Engineering guidelines for further information.

For high quality voice, the network connectivity must support a voice-quality grade of service

(packet loss


6/14

Licensing and Option Selection - SIP Licensing

Ensure that the 3300 ICP is equipped with enough SIP Device licences for the connection of SIP end points.This can be verified within the License and Option Selection form.

Figure 1 License and Option Selection

Document # 08-5159-00027 Page 6


7/14

Multiline IP Set Configuration

On the Mitel 3300 ICP, a SIP device can be programmed either in the User Configuration form or the Multiline

IP Set Configuration form and are programmed as a Generic SIP Phone. Enterprise Manager can also be

used to provision where this application is installed.

The Login PIN is the SIP authentication password and the username is the DN. The Number and Login PINmust match the information in the Nokia E71 Mobile Phone configuration. All other field names should beprogrammed according to the site requirements or left at default.

Figure 2 Multiline IP Set Configuration

Document # 08-5159-00027 Page 7


8/14

Class of Service Assignment

The Class of Service Options Assignment form is used to create or edit a Class of Service and specify itsoptions. Classes of Service, identified by Class of Service numbers, are referenced by the Station Service

Assignment form for the SIP devices.

Figure 3 Class of Service Assignment

Document # 08-5159-00027 Page 8


9/14

Figure 4 Class of Service Assignment (Cont)

Document # 08-5159-00027 Page 9


10/14

SIP Device Capabilities Assignment

This form provides configuration options that can be applied to various types of SIP devices. The associationbetween the SIP device and the form is similar to how the Class of Service options work. The SIP DeviceCapabilities number provides a SIP profile that can be applied to particular SIP devices to allow for alternatecapabilities as recommended through the Mitel interop process.

In the Device Capabilities form, program a SIP Device Capabilities Number for the Nokia E71 Mobile Phonedevice. Ensure that Replace System based with Device based In-Call Feature is set to Yes.For call hold, Prevent the use of IP Address 0.0.0.0 in SDP Messages and Force sending SDP in initial Invitemessage have to be enabled.

Figure 5 SIP Device Capabilities Assignment

Document # 08-5159-00027 Page 10


11/14

Station Service Assignment

Use the Station Service Assignment form to assign the previously configured Class of Service and SIP DeviceCapability number to each of the Nokia E71 Mobile Phones in the 3300. This form utilizesRange programming.

Select the Nokia E71 Mobile Phone device number then select Change. Enter the previously configured SIPDevice Capability number and Class of Service for Day, Night 1 & Night 2.

Figure 6 Station Service Assignment

Document # 08-5159-00027 Page 11
https://192.168.101.10/uwi/help/En/sysadmin/programming/range_programming.htmlhttps://192.168.101.10/uwi/help/En/sysadmin/programming/range_programming.htmlhttps://192.168.101.10/uwi/help/En/sysadmin/programming/range_programming.html


12/14

Multiline Set Key Assignment

You use the Multiline Set Key Assignment form to assign the line type, ring type, and directory number to eachline selected on the Nokia E71 Mobile Phone device.

Figure 7 Multiline Set Key Assignment Form

Document # 08-5159-00027 Page 12


13/14

Nokia E71 Mobile Phone Setup Notes

The following steps show how to program the Nokia E71 Mobile Phone to interconnect with the 3300 ICP.

1. SIP Settings

On Nokia E71 Mobile phone: MenuToolSettingsConnectionSIP Settings

a. Main Settings

Profile Name: 3211

Service profile: IETF

Default access point: Connection2 (Access Point)

Public user name: [email protected] (Extension Number @3300ICP_IP_address)

Use compression: No

Registration: Always on (When needed is deregistration)

Use security: No

b. Proxy Server Settings

Proxy server address: 192.168.101.10 (3300 ICP address)

Realm: sipint1 (Need to be 3300 name configured in Network Element assignment)

User name: 3211

Password: SIP Password. It must match the one in 3300ICP

Allow loose routing: Yes

Transport type: UDP

Port: 5060

c. Registrar Server SettingsRegistrar server address:192.168.101.10 (3300 ICP address)

Realm: sipint1 (Need to be 3300 name configured in Network Element assignment)

User name: 3211

Password: SIP Password. It must match the one in 3300ICP

Transport type: UDP

Port: 5060

2. Internet Telephone (net call setting): MenuToolSettingsConnectionInternet tel.

Assigning SIP Profile to Internet Telephone (net call setting)

Name: 3211

SIP Profiles: 3211

3. Communication: MenuCommunic.Internet tel.

Select Connection2 and Press Option to change service, selecting net call service (3211) from the list.

4. Registration

Registration: Selecting Always on, the phone will be registered.

Selecting When needed, the phone will be deregistered.

Document # 08-5159-00027 Page 13


14/14

5. Call Transfer

Unsupervised Call Transfer: press options and select Automatic transfer

Supervised Call Transfer: select New call and make second call, and then select transfer

6. Call Park

Using Refer method (Automatic transfer) to do call park

Document # 08-5159-00027 Page 14

Configure Nokia E71WiFi SIP Client With the 3300

Documents

Transcript of Configure Nokia E71WiFi SIP Client With the 3300