Compiling From Source Using Webattery program for open source lab
-
Upload
chandrasekar-raguraman -
Category
Documents
-
view
80 -
download
5
description
Transcript of Compiling From Source Using Webattery program for open source lab
![Page 1: Compiling From Source Using Webattery program for open source lab](https://reader034.fdocuments.net/reader034/viewer/2022052317/55cf9b90550346d033a68e91/html5/thumbnails/1.jpg)
Reg. No : 50410104020
COMPILING FROM SOURCE USING WEBATTERY
STEPS TO BE FOLLOWED:
1. Download RPM file from website.
2. Choose that file from Downloads folder.
![Page 2: Compiling From Source Using Webattery program for open source lab](https://reader034.fdocuments.net/reader034/viewer/2022052317/55cf9b90550346d033a68e91/html5/thumbnails/2.jpg)
Reg. No : 50410104020
3. Change to that folder using “cd /home/fosslab”.
4. Extract the rpm file using the command “rpm –ivh webattery-1.2-6.el5.src.rpm”.
5. It creates a folder named “rpmbuild” where it is extracted.
![Page 3: Compiling From Source Using Webattery program for open source lab](https://reader034.fdocuments.net/reader034/viewer/2022052317/55cf9b90550346d033a68e91/html5/thumbnails/3.jpg)
Reg. No : 50410104020
6. In that rpmbuild folder there are “SOURCES and SPECS” folders.
7. Inside SOURCES folder there is a “.tar” file.
8. Change to that path using “cd rpmbuild/SOURCES/
![Page 4: Compiling From Source Using Webattery program for open source lab](https://reader034.fdocuments.net/reader034/viewer/2022052317/55cf9b90550346d033a68e91/html5/thumbnails/4.jpg)
Reg. No : 50410104020
9. Extract that file using the command “tar zvfx webattery-1.2.tar.gz”.
10. It gets extracted in SOURCES folder and a folder “webattery-1.2” is created.
![Page 5: Compiling From Source Using Webattery program for open source lab](https://reader034.fdocuments.net/reader034/viewer/2022052317/55cf9b90550346d033a68e91/html5/thumbnails/5.jpg)
Reg. No : 50410104020
11. Change to that folder using “cd webattery-1.2/ and use the command “./configure”.
12. Now change to SuperUser using “su” and enter “make” commands.
![Page 6: Compiling From Source Using Webattery program for open source lab](https://reader034.fdocuments.net/reader034/viewer/2022052317/55cf9b90550346d033a68e91/html5/thumbnails/6.jpg)
Reg. No : 50410104020
13. Enter the command “make install” to install it.
14. Now exit from SuperUser. Use “which webattery” to check the location and “webattery” to check the status.