CLOCK AND DATA CONFIGURATIONservice.morphotrak.com/content/Documents/Clock and data.pdf · what is...
Transcript of CLOCK AND DATA CONFIGURATIONservice.morphotrak.com/content/Documents/Clock and data.pdf · what is...
ACRONYMS
MWC=MORPHO WAVE COMPACTUP=USER POLICYBDP=BIOMETRIC DEVICE PROFILEMM=MORPHO MANAGERACP=ACCESS CONTROL PANELCSN=CARD SERIAL NUMBER
WHAT IS CLOCK AND DATA
UTILIZING TWO WIRES, CALLED "CLOCK" AND "DATA". THE DATA LINE IS USED TO SEND ALL THE BINARY DATA TO THE PANEL. THIS IS ACCOMPLISHED BY CHANGING THE STATE OF THE VOLTAGE ON THE LINE.
ADD AN BIOMETRIC DEVICE
Administration>Biometric Device
Biometric devices from three different hardware families can be added here; the MA 100, MA J, MA 500, and MA VP family, the MA Sigma, MA Sigma Lite And MA Sigma Lite + MA Sigma Extreme, the Morpho 3D Face, the MorphoWave Tower, MorphoWave Compact, and the Morpho Tablet Terminal.
CLIENTS
Path Administration>Clients
Clients are computers that have the MorphoManager Client software installed and communicate with aMorphoManager server
USE A SIGMA TO CAPTURE
FINGERPRINTS
**IF YOU HAVE A MSO NO CHANGES
NEED TO TAKE PLACE
DROP DOWN
SELECTED
MORPHOACCESS
SEARCH FOR THE
READER
CREATION FOR CLOCK AND DATA
Path Administration>Wiegand Profile
This section allows you to view, add, edit & delete Wiegand Profiles in MorphoManager. WiegandProfiles define what information is output over the Wiegand Out interface of the Morpho BiometricDevices when a user is identified. This is most typically used in conjunction with an Access ControlSystem.
BIOMETRIC DEVICE PROFILE
Path Administration>Biometric Device Profile
The Biometric Device Profile will define common settings and parameters for one or more biometric devices. This profile can be applied when adding units into the system from the Biometric Device section of Administration
WIEGAND PROFILE: YOU MUST PICK THE CLOCK AND DATA FORMAT YOU CREATED EARLIER
BIOMETRIC DEVICE PROFILE
ACCESS CONTROL MODE MUST BE SET TO CUSTOMCLOCK AND DATA WILL BE AUTOMATICALLY CHECKED
DURESS WIEGAND MODE MUST BE SET TO DISABLED
BIOMETRIC DEVICE PROFILE
USER POLICY
Path Administration>User Policy
Create new User Policy
Select the User Policy that this user will belong to. This is an important selection, as the policy will determine Biometric Device access and other access control and time & attendance settings.
USER POLICY CREATE A NEW USER POLICY
WIEGAND PROFILE: USE THE CLOCK AND DATA FORMAT YOU CREATE EARLIER
USER AUTHENTICATION MODE: IS FOR HOW THIS USER WILL AUTHENTICATE
ENROLLMENT PROCESS
USER MANAGEMENT
Users are people who will have their biometric data sent to the selected Biometric Device for identification purposes for either access control or time and attendance.
MANUALLY TYPE IN THE USER ID NUMBER, THIS NUMBER WILL ALSO BE SENT TO YOUR
ACP AFTER VERIFICATION TAKES PLACE
USER MANAGEMENT
FINAL RESOLUTION
CLOCK AND DATA NEEDS TO BE CREATED FIRST UNDER WIEGAND PROFILES
BIOMETRIC DEVICE PROFILE MUST CONTAIN THIS CLOCK AND DATA FORMAT
USER POLICY MUST CONTAIN THIS CLOCK AND DATA FORMAT