Classic Gun MANUAL · 2018-09-28 · Suds Blaster PACKAGE 1 Classic Gun w/10 ft. of fluid hose &...
Transcript of Classic Gun MANUAL · 2018-09-28 · Suds Blaster PACKAGE 1 Classic Gun w/10 ft. of fluid hose &...
Classic Gun
MANUAL
Suds Suds BlasterBlaster
PACKAGE1 Classic Gun w/10 ft. of fluid hose & switch wire1 Gun Barrel w/ fluid tip1 Window Boot w/ stainless steel ring2 Black window mounting rings4 #8 Bolts and Nuts4 Nylon Spacers
Suds Blaster Gun Mounting
Here is 3 mounting styles for the gun, this depends on the design of your wash tunnel.
This is 3 possible scenarios.
Fluid Hose and Switch Wires
Fluid tube and trigger switch holeDrill 5/8 in. hole in base
for wires and hose
Wire & hose hole
Mounting hole for 1/4 in. bolt
Place 4 bolts with rubber bushings inside 5 in.hole in glass. Each bushing has a inner and outer piece.
Cut a 5 inch diameter hole in glass 9 3/8 inchesfrom bottom of gun base to center of 5 inch holein glass.
Align the bolts to the top and bottom of the glass, like in photo below. Position the angleof the boot to face down to the bottom.
The finished piece looks like this with thewindow between the 2 black ABS rings.
6.5 in.6.5 in.
5.in.5.in. 5. in.5. in.
9.375 in.9.375 in.9.375 in.Distance of Centerof 5 in. WindowHole to Base Plate
Gun Base toWindow Distance
6.25 in.