Chapter 9

37
9.1 Chapter 9 Using Telephone and Cable Networks for Data Transmission Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display.

description

Using Telephone And Cable Networks for Data Transmission

Transcript of Chapter 9

Page 1: Chapter 9

9.1

Chapter 9

Using Telephoneand Cable Networks

for Data Transmission

Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display.

Page 2: Chapter 9

9.2

9-1 TELEPHONE NETWORK9-1 TELEPHONE NETWORK

Telephone networks use circuit switching. The Telephone networks use circuit switching. The telephone network had its beginnings in the late telephone network had its beginnings in the late 1800s. The entire network, which is referred to as the 1800s. The entire network, which is referred to as the plain old telephone systemplain old telephone system ( (POTSPOTS), was originally an ), was originally an analog system using analog signals to transmit voice.analog system using analog signals to transmit voice.

Major ComponentsLATAsSignalingServices Provided by Telephone Networks

Topics discussed in this section:Topics discussed in this section:

Page 3: Chapter 9

9.3

Figure 9.1 A telephone system

Endoffices

Local loop

Trunk

Tandemoffices Regional offices

Trunk

• • •

Page 4: Chapter 9

9.4

Intra-LATA services are provided by local exchange carriers.

Since 1996, there are twotypes of LECs: incumbent local

exchange carriers and competitive local exchange carriers.

Note

Page 5: Chapter 9

9.5

Figure 9.2 Switching offices in a LATA

Page 6: Chapter 9

9.6

Figure 9.3 Point of presences (POPs)

Page 7: Chapter 9

9.7

The tasks of data transfer and signaling are separated in modern telephone

networks: data transfer is done by one network, signaling by another.

Note

Page 8: Chapter 9

9.8

Figure 9.4 Data transfer and signaling networks

Page 9: Chapter 9

9.9

Figure 9.5 Layers in SS7

Page 10: Chapter 9

9.10

9-2 DIAL-UP MODEMS9-2 DIAL-UP MODEMS

Traditional telephone lines can carry frequencies Traditional telephone lines can carry frequencies between 300 and 3300 Hz, giving them a bandwidth of between 300 and 3300 Hz, giving them a bandwidth of 3000 Hz. All this range is used for transmitting voice, 3000 Hz. All this range is used for transmitting voice, where a great deal of interference and distortion can where a great deal of interference and distortion can be accepted without loss of intelligibility.be accepted without loss of intelligibility.

Modem StandardsTopics discussed in this section:Topics discussed in this section:

Page 11: Chapter 9

9.11

Figure 9.6 Telephone line bandwidth

Page 12: Chapter 9

9.12

Modemstands for modulator/demodulator.

Note

Page 13: Chapter 9

9.13

Figure 9.7 Modulation/demodulation

Page 14: Chapter 9

9.14

Figure 9.8 The V.32 and V.32bis constellation and bandwidth

Page 15: Chapter 9

9.15

Figure 9.9 Uploading and downloading in 56K modems

Page 16: Chapter 9

9.16

9-3 DIGITAL SUBSCRIBER LINE9-3 DIGITAL SUBSCRIBER LINE

After traditional modems reached their peak data rate, After traditional modems reached their peak data rate, telephone companies developed another technology, telephone companies developed another technology, DSL, to provide higher-speed access to the Internet. DSL, to provide higher-speed access to the Internet. Digital subscriber lineDigital subscriber line ( (DSLDSL) technology is one of the ) technology is one of the most promising for supporting high-speed digital most promising for supporting high-speed digital communication over the existing local loops. communication over the existing local loops.

ADSLADSL LiteHDSLSDSLVDSL

Topics discussed in this section:Topics discussed in this section:

Page 17: Chapter 9

9.17

ADSL is an asymmetric communication technology designed for residential

users; it is not suitable for businesses.

Note

Page 18: Chapter 9

9.18

The existing local loops can handle bandwidths up to 1.1 MHz.

Note

Page 19: Chapter 9

9.19

ADSL is an adaptive technology. The system uses a data ratebased on the condition of

the local loop line.

Note

Page 20: Chapter 9

9.20

Figure 9.10 Discrete multitone technique

Page 21: Chapter 9

9.21

Figure 9.11 Bandwidth division in ADSL

Page 22: Chapter 9

9.22

Figure 9.12 ADSL modem

Page 23: Chapter 9

9.23

Figure 9.13 DSLAM

Page 24: Chapter 9

9.24

Table 9.2 Summary of DSL technologies

Page 25: Chapter 9

9.25

9-4 CABLE TV NETWORKS9-4 CABLE TV NETWORKS

The The cable TV networkcable TV network started as a video service started as a video service provider, but it has moved to the business of Internet provider, but it has moved to the business of Internet access. In this section, we discuss cable TV networks access. In this section, we discuss cable TV networks per se; in Section 9.5 we discuss how this network can per se; in Section 9.5 we discuss how this network can be used to provide high-speed access to the Internet.be used to provide high-speed access to the Internet.

Traditional Cable NetworksHybrid Fiber-Coaxial (HFC) Network

Topics discussed in this section:Topics discussed in this section:

Page 26: Chapter 9

9.26

Figure 9.14 Traditional cable TV network

Page 27: Chapter 9

9.27

Communication in the traditional cable TV network is unidirectional.

Note

Page 28: Chapter 9

9.28

Figure 9.15 Hybrid fiber-coaxial (HFC) network

Page 29: Chapter 9

9.29

Communication in an HFC cable TV network can be bidirectional.

Note

Page 30: Chapter 9

9.30

9-5 CABLE TV FOR DATA TRANSFER9-5 CABLE TV FOR DATA TRANSFER

Cable companies are now competing with telephone Cable companies are now competing with telephone companies for the residential customer who wants companies for the residential customer who wants high-speed data transfer. In this section, we briefly high-speed data transfer. In this section, we briefly discuss this technology.discuss this technology.

BandwidthSharingCM and CMTSData Transmission Schemes: DOCSIS

Topics discussed in this section:Topics discussed in this section:

Page 31: Chapter 9

9.31

Figure 9.16 Division of coaxial cable band by CATV

Page 32: Chapter 9

9.32

Downstream data are modulated using the 64-QAM modulation technique.

Note

Page 33: Chapter 9

9.33

The theoretical downstream data rateis 30 Mbps.

Note

Page 34: Chapter 9

9.34

Upstream data are modulated using the QPSK modulation technique.

Note

Page 35: Chapter 9

9.35

The theoretical upstream data rate is 12 Mbps.

Note

Page 36: Chapter 9

9.36

Figure 9.17 Cable modem (CM)

Page 37: Chapter 9

9.37

Figure 9.18 Cable modem transmission system (CMTS)