CES Bridge Building Rules & Tips 2010
description
Technical Guidelines and Tips on Popsicle Bridge Building Contest hosted by DLSU Civil Engineering Society (CES).
Transcript of CES Bridge Building Rules & Tips 2010
- 1.DLSU-CES BRIDGE Building Contest SY 2009-2010 Technical Guidelines
2. Truss Bridge Competition 3. Bridge Specifications
- Design atruss bridgethat will be laid on two smooth supports with a span length(S) of 560 mm .
- The bridge must satisfy the following specifications. (Refer to the figures)
-
- 560 mm Length (L) 770 mm
-
- Width (B) 140 mm
-
- Height ofTruss (H) 100 mmfrom the flat surface of the deck to the top
-
- Depth (D) 50 mmfrom the support surface to the flat surface of the bridge deck
-
- H + D 150 mm
-
- Weight (W) 1.50 kg
4. TRUSS Bridge Specs Weight, W 1.50 kg H+D150mm Length, L 770 mm Height H 100 mm Span Length, between UTM supports S = 560 mm UTM Support Provide a 60 mm minimum flat bearing surfaceat the supported points(see sample bridges) Bridge Deck Width B140 mm Top of UTM Depth D 50 mm 5. Sample Bridge Design A H L S D 6. Sample Bridge Design A H+D 150mm 7. Sample Bridge Design B H L S D 8. Sample Bridge Design B H+D 15 0 mm D 50 mm H 100 mm 9. Other Requirements
- No portion of the bridge structure shall extendbelowthe support surfaces.
- The bridge structure shall besymmetricalabout its longitudinal and transverse centerlines.
- The bridge must have asmooth surfacefor the bridge deck where atoy vehicle must be able to move.
10. Materials and Construction
- The bridge must be constructed using plainpopsicle sticks only .
- The popsicle sticksmay be cut or sandedin any manner.
- Onlyall purpose glue(white) must be used to connect the popsicle sticks.
- No other materialsmust be used.
- Do not paint, coat or stainthe bridge with any foreign substance.
11. Sample Bridge L = 700 mm, H = 200 mm, B = 130 mm,W = 1.26 kg 12. Pre-Qualification Screening
-
- REASONS FOR DISQUALIFICATION
-
- Not aTruss Bridge
-
- No flat surface on bridge deck where a toy car may pass
-
- Does not satisfy minimum required bridge span length (S)
-
- Exceeds the maximum total length (L)
-
- Exceeds the maximum height (H)
-
- Exceeds the maximum width (B)
-
- Exceeds the maximum depth (D)
-
- Exceeds H+D limit of 150 mm
-
- Exceeds the maximum weight (W)
-
- Other materials (paint, coating, etc) aside from popsicle sticks and glue used
-
- Portions of the bridge extend below the supports
13. Weight , W