CENTRIFUGAL PUMP MANUFACTURERS IN INDIA

 +(91)-9380545637,+(91)-9176603526

The centrifugal pump is the most used pump type in the world. The principle

is simple, well-described and thoroughly tested, and the pump is robust, effective

and relatively inexpensive to produce. There is a wide range of variations

based on the principle of the centrifugal pump and consisting of the

same basic hydraulic parts. The majority of pumps produced by Grund fos are centrifugal pumps.

Principle of the centrifugal pump:  An increase in the fluid pressure from the pump inlet to its outlet is

created when the pump is in operation. This pressure difference drives the

fluid through the system or plant. The centrifugal pump creates an increase in pressure by

transferring mechanical energy from the motor to the fluid through the rotating impeller. The fluid flows from the inlet to the impeller centre and out along

its blades. The centrifugal force hereby increases the fluid velocity and

consequently also the kinetic energy is transformed to pressure.

Different Types of Pump Head Total Static Head -  Total head when the pump is not running Total Dynamic Head (Total System Head) - Total head when

the pump is running Static Suction Head - Head on the suction side, with pump

off, if the head is higher than the pump impeller Static Suction Lift - Head on the suction side, with pump off,

if the head is lower than the pump impeller Static Discharge Head - Head on discharge side of pump

with the pump off Dynamic Suction Head/Lift - Head on suction side of pump

with pump on Dynamic Discharge Head - Head on discharge side of pump

with pump on

Typical Applications for Centrifugal Pumps:

Filling/draining Cooling tower transfer Filtration of corrosives, caustics, dyes,

soaps, brines, and other cleaning fluids Feed pumps for spraying systems General fluid transfer Line cleaning/irrigation Pilot plant processing

Use a Centrifugal Pump:

1.Electric driven and suitable for continuous duty

2.Excellent pulse less flow3.Fluid transfer at high flow rates, low

pressure4.Available in a range of materials

 Magnetic drive centrifugal pumps operate with a magnetic field that couples the impeller and motor together. There are no shafts or seals connecting the impeller and motor. Therefore friction loss, wear, contamination and leakage caused by these shafts and seals are eliminated.

        Mechanically coupled centrifugal pumps utilize a rotating impeller driven by a shaft with a seal that is connected to the motor. They are often less expensive than magnetic drive and can achieve high flow-rates and pressures.

Contact US:248/1, SIDCO Industrial Estate, Thirumudivakkam,Chennai - 600044 ,Tamil Nadu , India.Contact No : +(91)-(44)-42852038/0858697897Mobile : +(91)-9380545637,+(91)-9176603526Email : prakashprocess@gmail.comhttp://screwpumpmanufacturers.com/Centrifugal-pumps.html