CE403, 20081 Geometric rectification Homework 6. CE403, 20082 Description Objective: geometrically...
-
Upload
oliver-stephens -
Category
Documents
-
view
225 -
download
0
Transcript of CE403, 20081 Geometric rectification Homework 6. CE403, 20082 Description Objective: geometrically...
CE403, 2008 1
Geometric rectification
Homework 6
CE403, 2008 2
Description Objective: geometrically rectify a portion (~2km*2km) of SPOT image
over West Lafayette area Reference (GCP): to be measured from the USGS digital ortho quad
(DOQ). DOQ is used as the reference image Methodology: see the example Requirements:
at least 6 GCP and 6 check points need to be measured 10 meter spatial resolution for the rectified image
Data: ftp://ftp.ecn.purdue.edu/jshan/ce403/project6/ Hand in: a report including (max. 4 pages, 12 font, 1.5 line spacing)
A brief description of the work The rectified image with coordinate grid (you may use ArcView or
ArcGIS for output) and scale info in Letter format Layout of your selected GCP and their residuals Layout of your check points and their differences Evaluation/discussion on your results
Due: April 1 (Tuesday), 2008
CE403, 2008 3
Where to get help ? - Pdf documents
FieldGuide: photogrammetry principles
TourGuide: step-by-step tutorial by modules
OrthBASE: orientation, matching, triangulation, DEM generation
StereoAnalyst: feature collection, stereo map compilation
CE403, 2008 4
Where to get help ? on-line manual
CE403, 2008 5
For the “geometric rectification” project, check
FieldGuide: Chapter 9
One-line manual :TourGuide: Chapter 6
CE403, 2008 6
A worked example – tutorial
Landsat image is to be rectified
based on SPOT image, Atlanta
CE403, 2008 7
Choose one desired band to display
Image to be rectified – Landsat TM
To display only one band, use Raster > Band Combinations dialogue box as below
D:\IMAGINE 8.6\examples\tmAtlanta.img
CE403, 2008 8
Reference image – SPOT Pan
Load the SPOT Pan image in a separate viewer.
This image will be used as a reference image, i.e., any location on this image can be used as (2-D) ground control.
D:\IMAGINE 8.6\examples\panAtlanta.img
CE403, 2008 9
Steps for geometric rectification
In the first view (the image to be rectified), run Raster > Geometric Correction command
Choose Polynomial in the Select Geometric Model dialogue box, then click OK.
Click Close for now as below. (will make selection later)
CE403, 2008 10
Steps for geometric rectification
Choose OK in the right window (Existing Viewer is checked)
At the following prompt, Click the second viewer (the oneto be used as reference). This steplet you choose the reference image.
CE403, 2008 11
Steps for geometric rectification
Measure GCP. Note measure the 1st image (image to be rectified) first, and then the 2nd image (the reference image)
1st and 2nd polynomials can be tested. Rarely go beyond 2nd order. However, you can test what happens if so is chosen.
Measure a number of check points to evaluate the quality of rectification
Analyze the error distribution and decide if more GCPs are needed and where.
Check the on-line TourGuide for details.