Company

Logo

Camshaft testing system

http://www.isc-net.co.jp

Company

Logo

A check jig about camshaft inspection can do an imaging check of 1 cam in 1 camshaft.It‘s an organization. This inspection result is the part which becomes a stone of product equipment.

● About an inspection jig organization

Please make them do a camshaft 1 revolution more than a motor targeted for the reach of 2 cams (A journal is included.) more than 1 camera.Imaging is performed. The picture taken in more than a camera chooses a picture as synthetic processing for 1 revolution, and is a development picture for 1 revolution of cam.It‘s made and a nest and KAKE are detected by analysis processing based on this picture.

Shaft revolution(Motor)

Medical table (the shelter type)

A of illuminationx

The camshaft inspection environment

Company

LogoAbout inspection processing of a bruise

(nest and KAKE),-1This picture inspection developed the base part of a check analysis engine of product equipment and did inspection processing.Taking a camera imaging picture of following contents (cam part) in for 1 round of cam, and after developing the picture, it‘s in the cam, it exists. A bruise (nest and KAKE) is indicated by a measure frame.

カメラからの取込画像

Company

Logo

The picture one for 1 revolution took in more than a camera will be the following development picture.It breaks off from 1 revolution whole picture for the 1 cam, and measure processing of a nest is performed.

The state that a nest and breaking were detected more than a development picture 1 revolution on the check soft screen

Nest measure

Lack nest measure

About inspection processing of a bruise (nest and KAKE),-2

Company

LogoThe practical use type camshaft

check equipment

Actual practical use type camshaft check equipment is the following contents more than a camshaft inspection result.

＊＊＊＊＊ About the practical use type camshaft check equipment.＊＊＊＊＊

●Mechanism part

(1)①It‘s even possible to be once of check and check 4 camshafts.

(2)② A camera measures 2 cams + 4 of JANARU by 1 camera by composition.

(3)③Illumination for for cam irradiation and reverse step measure 2 of illumination is composition and by which 1 camshaft is everything.

●Inspection processing part

(1)①The camera imaging data fetch which is 1 frame unit while revolving around a camshaft.

(2)② Synthesis develops for 1 revolution of imaging data, and lacking and measure processing of a nest are performed. Processing of(1) and(2) is repeated to the camshaft set by once, and an inspection result is output.

(3)③ The check information by a measure processing result is as follows. * Breaking, the point of view of the nest (the angle and the X-coordinate value) and the size. * Distinction of a presence of a reverse step of a journal.