Bul 140G Flex Cable Operator for 140G-G through K€¦ · Tenere lontano da contaminanti. (Seguire...
Transcript of Bul 140G Flex Cable Operator for 140G-G through K€¦ · Tenere lontano da contaminanti. (Seguire...
WARNING:
WARNUNG:
AVERTISSEMENT:
To prevent electrical shock, disconnect from power source before installing or servicing. Install in suitable enclosure. Keep free from contaminants. (Follow NFPA70E requirements).AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti. (Seguire i requisiti NFPA70E).
Vor Installations- oder Servicearbeiten Stromversorgung zur Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen Sie die Anforderungen nach NFPA70E).
Avant le montage et la mise en service, couper l'alimentation secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée. Protéger le produit contre les environnements agressifs. (Vous devez respecter la norme NFPA70E).ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada. Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de contaminantes. (Cumpra as exigências da norma NFPA70E).
Installation - Installazione - Instalación Instalação - -
140G-G-F____, 140G-H-F____, 140G-I-F____, 140G-J-F____, 140G-K-F____
Installation instruction for Flex Cable Operator for 140G-G through KIstruzioni di installazioneInstallationsanleitungInstructions pour l’installationInstrucciones de instalación
CLACK
Bul. 140G/140MG
M4 x .7 x 12 mm140G-G140G-H140G-I140G-J
140G-K
PN-353709DIR 10000873178 (Version 05)
M4 x .7 x 12 mm
1/4-20 x .71 in
#10-32 x .22 in
#6-32 x .312 in
(2)PN-353709DIR 10000873178 (Version 05)
140G-K Shown
Provided with Circuit Breakers
U >0Ve
> 1.0” (25 mm)
Cable Length Diameter (Min.)3 ft (0.9 m)4 ft (1.3 m)6 ft (1.9 m)
10 ft (3.0 m)
6.0”(152.4 mm)12.0”(304.8 mm)12.0”(304.8 mm)12.0”(304.8 mm)
6.929 in(176.0 mm)
1.181 in(30.0 mm)
1.831 in(46.5 mm)
4.370 in(111.0 mm)
H
K
1
1
0.984 in(25.0 mm)
1.378 in(35.0 mm)
4.213 in(107.0 mm)
4.803 in(122.0 mm)
G I
1
10 - 15 lb-in1.2 - 1.7 Nm
10 - 15 lb-in1.2 - 1.7 Nm
(3)PN-353709DIR 10000873178 (Version 05)
140G-K
140G-G140G-H140G-I140G-J
M4
M5
M4
M4
5.472 in(139.0 mm)
1.378 in(35.0 mm)
J
M4
2
3
(4)
10 - 15 lb-in1.2 - 1.7 Nm
PN-353709DIR 10000873178 (Version 05)
140G-K Shown
T-20
140G-M1, -P1 or -S1
(5)
4
5
PN-353709DIR 10000873178 (Version 05)
140G-K Shown
140G-K Shown
Enclosures with Right Hand Flange Enclosures with Left Hand Flange
Enclosures with Right Hand Flange Enclosures with Left Hand Flange
90°
OFF
OFF
90°
7 - 11 lb-in(0.8 - 1.2 Nm)
7 - 11 lb-in(0.8 - 1.2 Nm)
3
3
3
3
2
1
1
2
2
1
2
1
#2#2
7/16"(11 mm)
7/16"(11 mm)
30 - 40 lb-in(3.5 - 4.5 Nm)
30 - 40 lb-in(3.5 - 4.5 Nm)
PN-353709DIR 10000873178 (Version 05) (6)
CLACK
1 - Trip Breaker
2 - Reset Breaker
CLACK
See figure AVedi figura ASiehe Abb. AVoir figure AVéase figura A
See figure AVedi figura ASiehe Abb. AVoir figure AVéase figura A
See figure BVedi figura BSiehe Abb. BVoir figure BVéase figura B
OK!
NO!
OK!
4 - Breaker Off
NO!
OK!
3 - Breaker On
NO!
OK!
CLACK
PN-353709DIR 10000873178 (Version 05) (7)
A
3/4"(19 mm)
B
3/4"(19 mm)
RESETOFF
ON
PN-353709DIR 10000873178 (Version 05)
Copyright © 2016 Rockwell Automation, Inc. All Rights Reserved. Printed in USA.Publication 140G-IN128F-MU-P - March 2016
Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.Trademarks not belonging to Rockwell Automation are property of their respective companies.
Rockwell Automation maintains current product environmental information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/sustainability-ethics/product-environmental-compliance.page.
CONFIDENTIAL AND PROPRIETARY INFORMATION. THIS DOCUMENT CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF
ROCKWELL AUTOMATION, INC. AND MAY NOT BE USED, COPIED OR DISCLOSED TO OTHERS, EXCEPT WITH THE AUTHORIZED WRITTEN
PERMISSION OF ROCKWELL AUTOMATION, INC.
Sheet
Size Ver
Of 11
A 0110000021668Dr. DateG. USHAKOW 8-23-13
MATERIALSIZE
FOLD
TWO SIDES PRINTEDBODY STOCK WHITE
BODY INK BLACK8-1/2" W x 11" H
FLAT
17" W x 11" H
SPECIFICATIONS FOR8 PAGE INSTRUCTION SHEET8-1/2” W x 11” H - FINAL FOLD
Page Layout
8 - 1/2"8 - 1/2"
17" 17"
Front SidePage 1
Back SidePage 2
Front SidePage 8
Back SidePage 7
Front Side
Saddle Stitched Saddle Stitched
Page 3
Back SidePage 4
Front SidePage 6
Back SidePage 5
8 - 1/2"8 - 1/2"
Final Fold
11”8-1/2”
Note: After folding---Printed in (Country where printed*), part number(s) and barcode (when used) should be visible.
* The printing vendor may change the instruction sheet files to show the correct country.
11"
PN-123456DIR 10000000000 (Version 00)Printed in U.S.A.
BARCODE