Build-In Ref Programming Guide Power Point Copy
41
-
Upload
buckley799 -
Category
Documents
-
view
19 -
download
2
description
Viking Refrigeration Programming Guide
Transcript of Build-In Ref Programming Guide Power Point Copy
-
Side x Sides are set at 7
-
Bottom Mount, AR & AF are set at 4
-
These should not ever need to be adjusted. The information is in your programming charts in case you are working with the Tech Line and they ask you to go here.
-
9th Temp bar.
-
Keep in mind that any changes you make will not be saved unless when you are finished you press and hold Activate Control/Display On Key.
-
Check and setAnytime you change a board You have to check to make sure it is set right!OffsetsMode SettingVCC SettingsEVERYTIME!
-
Thank You