Breaching System Views Safety First Breaching system can conduct electricity Do not use in flammable...
-
Upload
amira-gatliff -
Category
Documents
-
view
218 -
download
1
Transcript of Breaching System Views Safety First Breaching system can conduct electricity Do not use in flammable...
Breaching System Views
Safety First
• Breaching system can conduct electricity
• Do not use in flammable atmosphere
• Use proper personal protective equipment
• Gasoline is explosive
• Spinning motion produces torque
System Set-Up
System Set-Up
Remove accessories from case
Mount water collar to output shaft
System Set-Up
Select proper bit and thread onto spindle
Copper washer prevents binding
Starting Engine
Starting Engine
• Fill with gasoline
• Open fuel valve at bottom of tank
Starting Engine
Prime carburetor
Starting Engine
Close choke
Starting Engine
Throttle to half-open
Starting Engine
Switch ignition to ‘start’
Starting Engine
Pull handle until unit starts
Coring Bits
Coring Bits
• Carbide Bit
• Diamond Segment Bit
Coring Bits
• Diamond Segment Bit
• Cuts through concrete, masonry, stone, rebar
• Must be cooled with water during cutting
Coring Bits
• Carbide Bit
• Cuts through wood, sheet metal, roofing material
• Do NOT USE water during cutting with the carbide bit
System Care
System Care
Engine Maintenance
• Always use freshly-mixed fuel at 25:1 gasoline/oil ratio
• Clean or replace fuel filter (inside fuel tank) after every 10 hours of operation
System Care
Air Filter
• Clean air filter (inside side cover) after every 10 hours of operation
• Check spark plug for fouling
• Change gear oil every 20 hours of operation
System Care
Water Collar
• Inspect water collar for free motion, leaks around seals
• After each use, spray a few drops of oil into the engine cylinder
System Care
• Inspect and clean the bit with a wire brush
• Check for roundness, dents, etc.
• If diamond flakes are obscured, ‘dress’ the bit by drilling into a masonry block or asphalt
• Inspect mounting threads
• Diamond Segment Bit
System Care
• Inspect and clean the bit with a wire brush
• Check for roundness, dents, etc.
• Inspect mounting threads
• Carbide Bit
System Care
Spray lubricant into the bit threads
System Care
Spare parts inventory furnished with system
System Storage
System Storage
• Store system in case provided
• Never store with fuel in system or case
• Store in dry location not exposed to excess cold or heat
Search Systems, Inc. PO Box 80307 Bakersfield, CA 93380 1-800-722-2824 1-661-588-6270www.searchsystems.com