Artwork specification guide for Simply Plastic Cards

download Artwork specification guide for Simply Plastic Cards

of 6

  • date post

    17-Jul-2015
  • Category

    Marketing

  • view

    58
  • download

    2

Embed Size (px)

Transcript of Artwork specification guide for Simply Plastic Cards

  • GUIDEKASpecification

    Part of the Nitecrest group of companies

  • 85.6mm

    54mm

    Design size

    Front

    Back

    bleed

    CutterSafety

    Requirements

    Provide PANTONE colour specifications where applicable

    Provide 3mm bleed area

    All images should be at 300dpi

    Provide artwork files in a jpeg, png, tiff or PDF format.

    All blacks should be set to 100%

    Requirements

    Provide PANTONE colour specifications where applicable

    Provide 3mm bleed area

    All images should be at 300dpi

    Provide artwork files in a jpeg, png, tiff or PDF format.

    All blacks should be set to 100%

    Allow 3mm bleed of artwork around the outside of the cutter. line.

    The card will be cut from this line.

    No text or logos should be within this area.

    All artwork must be supplied in a CMYK colour formatAll artwork must be supplied in a CMYK colour format

    No text to be below 6pt in sizeNo text to be below 6pt in size

  • 85.6mm 28.4mm

    54mm

    Design size M25

    Front

    bleed

    CutterSafety

    Allow 3mm bleed of artwork around the outside of the cutter. line.

    The card will be cut from this line.

    Back

    No text or logos should be within this area (1.5mm) .

  • Design size M6

    bleed

    CutterSafety

    Allow 3mm bleed of artwork around the outside of the cutter. line.

    The card will be cut from this line.

    Back

    85.6mm

    70mm

    54mm

    No text or logos should be within this area (1.5mm) .

    Front

  • 85.6mm

    54mm

    Design size Tritag

    bleed

    CutterSafety

    Allow 3mm bleed of artwork around the outside of the cutter. line.

    The card will be cut from this line.

    No text or logos should be within this area (1.5mm) .

    Front28.54mm 28.54mm 28.54mm

    Back

  • Extras

    Mag Stripe

    Scratch Panel

    Cut out/ slot

    4.3mm

    12.7mm

    8.4mm

    Mag Stripe

    4.3mm

    All slots and cutouts need 1.5mm bleed all around

    Our standard size scratch panel is 36x6mm and needs a clearance of 1mm (38x8mm). Within this clearance a white space of 33x4.5mm should be .

    Signature Panels can be any size but still need 1.5mm of clearance.

    Signature Panel

    Artwork Specification Guideartwork-specification