Application Instructions

Bonds to Polyethylene, PVC, Steel, Fiberglass, and Aluminum

Description

BonDuitTM Conduit Adhesive is a two-part, rapid-cure resin system designed to bond polyethylene, PVC, fiberglass metals and composites. It forms a durable long-lasting, strong bond that is airtight and watertight.

Easy To Use

Create a splice in less than 5-minutes.

No special tools

No specialtraining needed

BonDuitTM BT-KIT

The BT-KIT contains all material to make a joint. BonDuitTM BT-KITG includes the application tool for applying BonDuitTM.

Cut ConduitTo prepare the splice, cut conduit to the desire length. Make a 90o angle cut. Taper edges with a rasp or knife to a 45o angle.

Sanding Conduit

Use 80-grit abrasive cloth to sand outside of conduit ½ inch beyond the depth of the coupling.

Sand Coupling

Use 80-grit abrasive cloth to sand inside of coupling. Surface should be rough with all polish removed.

Clean Coupling and Conduit

Clean sanded surfaces of both conduit & coupling with TRTM Cleaner to remove any oils and displace moisture.

BonDuitTM Cartridge

BonDuitTM Adhesive is packaged in a 1.7oz (50 ml) multi-use cartridge.

Static mixer combines the two parts.

Dispensing Tool

Insert cartridge into dispensing tool for an easy, clean way to mix and apply BonDuitTM Conduit Adhesive.

Prime The Cartridge

Prime the cartridge by depressing the handle 1 to 2 times after the material is coming out of the nozzle. This will make sure you are getting an even mixture.

Applying BonDuitTM

Place BonDuitTM in a 1/8- to 1/4-inch bead around the outer edge of the conduit.

Placing Coupling on ConduitPlacing Coupling on Conduit

Immediately twist coupling onto the conduit. Smooth any excess BonDuitTM.

Finished

Watertight and airtight seals.High-strength durable bond. Finish in minutes. No special tools or training.