www.tritonsystems.co.uk

Sho

rt P

age

Triton Systems

Units 3 – 5 Crayford Commercial Centre, Greyhound Way, Crayford, Kent DA1 4HF

Tel: 01322 318830 Fax: 01322 524017 Email: info@tritonsystems.co.uk

Triton Chemical Manufacturing Co Ltd trading as Triton Systems

0656 02/12

www.tritonsystems.co.uk www.tritonsystems.co.uk

Also available from TritonFlooring Systems (gas barriers, waterproofing and damp control)

Flood Resilience/Restoration

Replacement Cavity Wall Ties

Damp Proofing and Replastering Systems

Protective Coatings, Structural Repair

Timber Preservation and Repair

Green Roof Systems

Radon (ground gas) Barrier Systems

Concrete Waterproofing Systems

Structural Waterproofing Systems

Anti-Condensation Productsn Passive Air Vents

n Extraction Fans

n Heat Recovery Units

n Positive Pressure Units

255

270

274

Positive Pressure UnitsPositive pressure units are designed to eliminate moisture from the home by a

constant circulation of gently pressurised, clean air. Installed in either the loft of

a house or a hallway cupboard in a flat, the gentle pressurisation of the property

expels any stale, humid air through natural ventilation points which are present

in even the most insulated buildings.

Running costs: Both the units described below are rated at 7 watt slow and

14 watt fast. Assuming electricity costs of 12 pence per unit, and that the units

might be used for an average of one hour per day, running costs would equate

to just 3 pence per day/21 pence per week.

TRITON PPU LOFT

Loft mounted model for installation in properties with lofts. Low wattage with

2-speed manually operated switch. Extract speed 55 litres/second on fast

speed or 44 litres/second on slow speed. Noise level (at full speed) is just

25dBA.

Up to four humidity sensors can be fitted around the home all connected back

to the main unit to ensure total control. The air is delivered to the property

through a centrally located inlet grille on the landing or hallway ceiling.

TRITON PPU FLAT

Cupboard mounted model for properties without lofts. Low wattage with 2-speed

manually operated switch. Extract speed 55 litres/second on fast speed or 44

litres/second on slow speed. Noise level (at full speed) is just 20dBA.

The Triton PPU Flat can be connected to humidity sensors as described above.

Air is delivered to the property through a wall grille.

Construction The Triton PPU Loft is made from leather coated steel for strength, durability and finish. The Triton

PPU Flat is made from high strength plastic.

Electrical 220-230V ~ A.C. 50Hz Single phase consuming 30 watts max for both units. These units require

an earth. All wiring must comply with current IEE regulations. A double pole isolating switch, having

a contact separation of at least 3mm in all poles, must be used with a 3 amp fuse fitted.

Motor Single phase induction motor with pre-oiled ball-bearings fitted for a long maintenance free life and

protected by a thermal fuse.

Guarantee Two year no quibble guarantee.

Installation The fans are designed to be loft or cupboard mounted. The inlet grille must be mounted at

least 1m from any smoke detectors but full installation and operating instructions are provided

with each unit.

Performance Both units supply rate of 44 litres/sec on slow speed and 55 litres/sec on fast.

Fan Speed 2400 r.p.m.

Sound Volume 25.0 dBA Maximum operating temperature 40°C.

For further details and information about additional products in this range,

please contact your Triton technical sales representative.

Triton PPU Loft

Triton PPU Flat

GuaranteesTriton approved contractors have access to TUG Insurance Backed Guarantees which are issued for a maximum of 30 years and which cover wall tie replacement, below ground waterproofing and damp and timber treatment. The TUG Insurance Backed Guarantee provides peace of mind to clients by coming into force in the event of the approved contractor ceasing to trade.

Triton also issues its own guarantees to cover the performance of Triton products plus the workmanship of the Triton Approved Contractor. These are designed for contractors who do not issue their own company guarantees. Triton Guarantees are valid for up to 30 years from date of completion of the works (up to 10 years for below ground waterproofing).

Visit www.tug.uk.com to apply for Triton Approved Contractor status and to download the guarantee application forms.

About TritonThe company holds British Board of Agrement approvals

and is a BS EN ISO 9001 Quality Assured Company. Triton

was represented on the technical committee responsible

for drafting British Standard BS 8102 (2009) – the Code

of Practice for protection of below ground structures

against water from the ground – and supplies systems and

products to meet the requirements of all three methods of

waterproofing as defined by the Standard.

Triton also supplies associated products including

anti-condensation products, ground gas barriers, flood

resilience and remediation systems, cavity wall ties, damp

proofing and timber preservation systems.

To support architects, surveyors and contractors,

a full programme of training courses has been created

including RIBA approved CPD seminars on basement

waterproofing and green roof construction. More details

can be found at tritonsystems.co.uk/training

Anti-Condensation ProductsCondensation is the most common cause of dampness in

buildings and affects properties of all types and ages. In

particular it is directly associated with black mould growth.

Triton offers a comprehensive range of products to control

condensation including passive air vents, extractor fans,

heat recovery ventilators and positive pressure units.

This brochure gives an overview of all the anti-

condensation products in Triton’s range, but more detailed

information about each product, as well as other general

preventative measures which can be taken, is available at

tritonsystems.co.uk

EFFECTS OF CONDENSATION

Black mould growth is often the first visible sign of

condensation, usually present on decorative surfaces

such as wallpaper. The mould and its spores also cause

a musty odour and often give rise to respiratory health

problems. When condensation occurs in roof spaces or

sub floor areas, timbers in those areas can become damp

and susceptible to dry or wet rot.

It should be noted that black mould can only flourish on

the pure water associated with condensation – therefore it

is not an indication of rising damp.

Short P

age

TRITON SURFACE CLEANSER

n For use prior to painting with Triton Anti-Mould Emulsion

n Supplied as concentrate

Application: After removing non-washable or loose material, the dilution should

be used to wash down the surface using a sponge, scrubbing brush or cloth.

Allow to dry thoroughly, applying a second wash to badly soiled areas.

Drying Time: 1-4 hours normally.

Practical Coverage: 6-8m²/litre when diluted, depending on the porosity and

roughness of the surface.

Pack size: 250ml. Supplied as a kit with Triton Anti-Mould Emulsion.

TRITON ANTI-MOULD EMULSION

n Premium quality paint

n Guaranteed protection against black mould

n Tough surface finish

n Available in White or Magnolia

Application: Following the application of Triton Surface Cleanser, Triton Anti-

Mould Emulsion can be used as a primer for new or porous surfaces (thinned

up to 10% with clean tap water). Allow primer coat to dry thoroughly. Apply two

coats of Anti-Mould Emulsion using a brush or roller, allowing sufficient drying

time between coats.

Coverage: 10-12m²/litre but an extra allowance should be made for rough or

porous surfaces.

Drying Time: Touch dry in one hour and re-coatable after 2-4 hours.

Pack size: 2.5 litre (as a kit with Triton Surface Cleanser) and 5.0 litre.

TRITON ULTROVENT

n Quick and easy to install

n No ongoing costs

A range of passive ventilation units (airbrick cavity liner and core drill unit) that

incorporate triple action filters and specially designed thermal cores for minimal

heat loss. Extension kits are available to suit all wall thicknesses.

Triton Ultrovent units are designed to ventilate bedrooms and living rooms where

the constant background ventilation they provide allows water vapour to escape.

One air brick ventilator is usually sufficient for a singe room of up to 20m²

floor area, alternatively two core drill ventilators can be installed. Each unit is

supplied with positioning and installation instructions.

Technical Data:

Model Air Brick Ventilator Core Drill Ventilator

Velocity 0.09m/s 0.09m/s

Air diffusion/hour 9.34m3 3.98m3

Water diffusion/hour 0.12kg 0.05kg

Water dissipated over 24 hours

2.8 litres 1.2 litres

TRITON HEAT RECOVERY ROOM VENTILATOR

A continuous heat recovery unit which is suitable for use in kitchens, bathrooms

and lavatories, utility rooms, living rooms, washrooms, conservatories, offices

and bedrooms. Pull cord provides manual override option to facilitate additional

‘boost’ of fresh filtered air.

n Meets IEE, SELV and Building Regulation requirements

n Easy to install, no external access required

n Quiet in operation

n Humidity and night sensors

Installation: A through the wall unit designed for easy installation by use of a

152mm core drilled hole. Suitable for wall thicknesses from 229mm – 356mm.

Also available: Extension Kit for walls up to one metre thick; Window Kit

for installation through single or double glazed windows; Heat Recovery Units

for whole house/flat – please speak to Triton sales department for

more information.

TRITON LOW CARBON FAN TLC-1

n Low running costs

n Quiet in operation

Designed to deliver high efficiency, low carbon operation and low running costs.

Extremely quiet operation. Suitable for toilets, shower and bathrooms, utility or

kitchens. Operated by pull cord or remote switch.

For further details and information about additional products in this range,

please contact your Triton technical sales representative.

TRITON ECO-LINE FAN

n 3 speed

n Maintenance free

An energy efficient, three speed extraction fan designed to be installed in walls,

panels or windows. The Eco-line Fan runs silently and continuously at a choice

of two lower speeds. The user can then boost the fan speed to maximum

when required.

The Eco-line Fan will exhaust air directly to the outside or into a short length

ducting (max 3m length) and is suitable for toilets, bathrooms and shower rooms.

For further details and information about additional products in this range,

please contact your Triton technical sales representative.

www.tritonsystems.co.uk www.tritonsystems.co.uk www.tritonsystems.co.uk

Triton Low Carbon Fan TLC-1

Triton Heat Recovery Room Ventilator

Triton Eco-Line Fan

For further details and information about additional products in this range, please contact your Triton technical sales representative.

Air Brick Ventilator

Core Drill Ventilator