Annex D - Parabolic Mirrors Specifications
2
Item Requirement Requested Value/ Quality Verification Method R = Revision I = Inspection T = Test Parabolic Mirror OAP. 1 Reflected Effective focal length (mm) 9500 R OAP. 2 Off axis angle (full turning angle) (degree) 90 R OAP. 3 Material for mirror substrate Material with activation equal or lower than Fused silica R OAP. 4 Mirror Size * (mm) H = 650 L = 880 X = 630 Y = 860 T- Supplier R - Purchaser OAP. 5 Scratch-Dig Better than 20-10 as per MIL-O-13830A T- Supplier R - Purchaser OAP. 6 Reflectivity >98.5% T OAP. 7 Vacuum Compatibility (mbar) <10 -6 T- Supplier R - Purchaser OAP. 8 LIDT (Laser Induced Damage Threshold) 0% damage probability >0.4 J/cm^2 @800nm, for <50fs pulse @ laser repetition rate at least 10Hz T- Supplier R - Purchaser OAP. 9 GDD (Group delay dispersion) In order to satisfy the requirement Diag 1.2. from Annex J T- Supplier R - Purchaser Documents for commissioning ComOAP. 1 Dimensional report of optics Compliance R ComOAP. 2 Reflectivity Trace showing compliance of reflectivity at requested polarization in vacuum. Trace will be taken on a 1” sample traceable to the mirror. Compliance R ComOAP. 3 Interferogram data of clear aperture of optic after coating Compliance R ComOAP. 4 GDD measurement for witness samples traceable to the mirror Compliance R ComOAP. 5 Damage test reports for a number of 4 witness sample for each coating batch, to demonstrate that it reaches >0.4J/cm 2 , 0% damage probability @800nm, for <50fs pulse @ laser repetition rate at least 10Hz, S on one for S=1000. Witness shall be traceable to the mirror. The damage test shall be performed at 2 independent facilities (2 samples for each). Compliance R ComOAP. 6 Ellipsometric polarization curve measurement shall be provided, for each coating batch, for one witness sample traceable to the mirror. Compliance R ComOAP. 7 Certificate of Conformity Compliance R * Mirror dimensions in relation with the definition of the clear aperture in Clear Aperture sheet
-
Upload
press-escape -
Category
Documents
-
view
215 -
download
1
description
annex d
Transcript of Annex D - Parabolic Mirrors Specifications
-
Item Requirement Requested Value/ Quality
Verification
Method
R = Revision
I = Inspection
T = Test
Parabolic Mirror
OAP. 1 Reflected Effective focal length (mm) 9500 R
OAP. 2 Off axis angle (full turning angle) (degree) 90 R
OAP. 3 Material for mirror substrate Material with activation equal or lower than Fused silica R
OAP. 4 Mirror Size * (mm)
H = 650
L = 880
X = 630
Y = 860
T- Supplier
R - Purchaser
OAP. 5 Scratch-Dig Better than 20-10 as per MIL-O-13830AT- Supplier
R - Purchaser
OAP. 6 Reflectivity >98.5% T
OAP. 7 Vacuum Compatibility (mbar) 0.4 J/cm^2 @800nm, for 0.4J/cm2 , 0% damage probability
@800nm, for
-
Red area is the clear aperture of the mirror
L
H