A B C D E F G1

2 AA1100-H141.5 to 3.0mm thk

EN AW 3105-H14

EN AW 1100 - Al 99.0 EN AW 3105 1.2 to 6.3 mm thkAA1100-H14

1.2 to 2.0 mm thkAA3105-H14

34 Tensile Strength Mpa (min) 150 to 200 110 to 145 150 to 200

5 Elongation % (min) 2 5 2

67 Fe + Si %(max) 0.95 0.60 + 0.70 0.95 0.60 + 0.70

8 Cu % 0.05 -0.20 0.3 (max) 0.05 - 0.20 0.3 (max)

9 Mn % 0.05 (max) 0.30 to 0.80 0.05 (max) 0.30 to 0.80

10 Mg %(max) - 0.20 to 0.80 - 0.20 to 0.80

11 Cr %(max) - 0.20 - 0.20

12 Zn %(max) 0.10 0.40 0.10 0.40

13 Ti %(max) - 0.10 - 0.10

14 Al %(min) 99.00 Remainder 99.00 Remainder

Please Note:

BS EN 573-3BS EN 485 -2

Comparison Table BS EN 485, BS EN 573 and ASTM B209M-10

Mechnical Properties for Aluminium Alloy 1100-H14 is not specified in British Standard where as Chemical properties are specified but both have been specified in ASTM B209M-10 and we observe requirment of BS & ASTM is exactly same for chemical properties hence ASTM standard can be consider in absences of BS Standard for mechanical properties.

ASTM B209M-10

Mechanical Properties

Not Specified

Chemical Composition