All-Flex Servi-Sert® Field Assembled Riser

www.elster-perfection.com

Installation Instructions

Wipe the tubing with a clean, dry cloth and inspect the tubing for damage. If any, cut again to remove damaged area.

3

Chamfer the O.D. of the tubing.4

Remove the service head adapter from the flexible casing. Insert the tubing through the casing.

1

3

Cut the tubing so the end is square.2

2

4

1

(continued on opposite side)

Anodeless Risers - connect with safety, integrity and speed

Elster Perfection 222 Lake Street Madison, OH 44057USA

T +1 440 428 1171F +1 440 466 7351

www.elster-perfection.com

© 2007 Elster Perfection. All rights reserved

Information contained herein is subject to changewithout notice. Product specifications may change.Contact your Elster Perfection representative for the most current product information. Printed in the United States.

EP-II0003-EN-P - September 2007Supersedes LITC3-04150

About Elster Group

Elster Group is the world’s leading manufacturer and supplier of highly accurate, high quality, integrated metering and utilization solutions to the gas, electricity and water industries. In addition, through its subsidiary Ipsen International, it is the leading global manufacturer of high level thermo- chemical treatment equipment.

The group has over 8,500 staff, operations in 38 countries and serves over 115 markets around the world. Elster’s high quality products and systems reflect the wealth of knowledge and experience gained from over 170 years of dedication to measuring precious resources and energy.

7

6

5

Stab the tubing into the service head adapter until the stab depth mark is reached. See note in step 7.

6

Finally, hand tighten the service head adapter to the riser casing to complete the installation.

Note: The adapter will continue to spin freely on the tubing, simplifying the attachment to the riser.

7

Mark the stab depth as indicated on the package instructions.5