After Receiving this error code, Follow these steps to correct the problem…

Click for next slide

You will need a 6inch Philips head screwdriver

Click for next slide

8mm box wrench

Click for next slide

Remove screw from panel close to the control panel

Click for next slide

Then slide the panel to the right…

Click for next slide

Click for next slide

This L.E.D. light should be on, but with this type of error, it will be off…

Click for next slide

This part is called the “Spanner”, and is what you will adjust to correct the error.

Click for next slide

A closer look…Click for next slide

With the 8mm box wrench, adjust the spanner with a slight turn left or right…

Click for next slide

Until the L.E.D. light is on

Click for next slide

Press the “clear” button and clear the error from the screen.

Click for next slide

Press the “thread cut” button, and your done!