Activity 1-11: Curves of Constant Width .
-
Upload
kristopher-hines -
Category
Documents
-
view
215 -
download
0
Transcript of Activity 1-11: Curves of Constant Width .
How would you measure the width of a closed curve?
Suppose you took a rectangle
that is 2 cm by 1 cm:what is the
maximum width it could have? The minimum?
Is it possible to have a curve that is a constant width,
whichever direction this is measured in?
A circle clearly counts, but is there anything else?
There is a curve called a Reuleaux Triangle
that also qualifies.
Draw an equilateral triangle ABC, and then add
arc BC drawn with centre A, arc AC drawn with centre B, and
arc AB drawn with centre C.
There is nothing special about using a triangle here. You could do the same with a regular pentagon,
or any regular n-agon for n odd.In fact, our fifty-pence piece
and our twenty-pence piece are Reuleaux septagons. (What practical advantage might there be in this?)
Now there is a useful formula
called the Isoperimetric Inequality:
Barbier’s Theorem states thatevery curve of constant width w
has a perimeter of πw.
Equality holds if and only if the curve is a circle. (Check that equality holds for a circle!)
If any curve has perimeter L and area A, then 4πA ≤ L2.
So if our curve has perimeter πw, and area A, then A ≤ πw2/4.
Equality is achieved by the circle.
It can be proved that the area of the Reuleaux Triangleis a minimum for a curve of constant width w.
The area here is (-√3)w2/2 = 0.7047...w2.
http://www.cut-the-knot.org/Curriculum/Geometry/CWStar.shtml
There are in fact infinitely many curves of constant width that we
can create.
Curve of Constant Width
link
We could create a Reuleaux tetrahedron,
by drawing four spheres with centres
at the corners of a regular tetrahedron.
It seems intuitively obvious that this will be a solid of constant width,
but this is NOT the case!
If the tetrahedron’s edge-length is 1, and we measure the solid’s width from mid-arc to opposite mid-arc, we get the value 1.0249...
Meissner & Schiller (1912) showed how to modify the Reuleaux
tetrahedron to form two surfaces of constant width that are called
Meissner tetrahedra.
Throw away the dark shaded sharp sections above on three edges that meet at a vertex,
and replace them with rounded sections.
Campi, Colesanti & Gronchi (1996) showed that the minimum volume surface of revolution
with constant width is the surface of revolution of a Reuleaux triangle
through one of its symmetry axes.
Bonnesen & Fenchel (1934) conjectured that Meissner tetrahedra are the
minimum-volume three-dimensional shapes of constant width, a conjecture which is still open...
With thanks to:Chris Sangwin.
Wikipedia, for another excellent article.
Carom is written by Jonny Griffiths, [email protected]