A x 24 Pieces GAMBREL COOP ASSEMBLY · material.) Using roof pieces 13 and eight B screws, attach...
10
GAMBREL COOP ASSEMBLY A x 24 Pieces B x 24 Pieces C x 4 pieces D x 14 pieces 1 2 3 4 5 6 7 x2 8 9 10 11 12 x2 13 x2 14 x2 15 16 x3 17 x2 E x 2 Barrel Bolts page 1
Transcript of A x 24 Pieces GAMBREL COOP ASSEMBLY · material.) Using roof pieces 13 and eight B screws, attach...
GAMBREL COOP ASSEMBLYA x 24 PiecesB x 24 Pieces C x 4 piecesD x 14 pieces
1 2 3 45
6 7 x2 8
910
11
12 x2 13 x2 14 x2
1516 x3 17 x2
E x 2 Barrel Bolts
page 1
page 2
5STEP 1
4
62
A
A
A
A
A
A
AA
Using pieces 2, 4, 5 & 6 and eight A screws, assemble the sides, and front and back lower walls.
page 3
A
STEP 2
A
AA
AA
AA1
3
With pieces 1 & 3 and eight A screws, attach the front & back upper walls. The front upper wall has doors and should be positioned over the lower wall with a door.
page 4
A
STEP 3
A
AA
A
A
7 x2
A
A
With both 7 pieces and eight A screws, attach inner walls to upper section of coop. Make sure the side with the three roosting supports faces toward the middle of the coop.
page 5
STEP 4
8
9
Drop in pieces 8 and 9 into nest box areas. Make sure the nest box divider slot faces up. Piece 8 should be positioned such that the opening is in the back left of coop.
page 6
STEP 5
Using eight D screws, attach the two male pieces of the barrel bolts E to each side of the droppings tray, piece 11. Be sure that the top of the metal is flush with the top of the droppings tray. Slide droppings tray into coop and, with the barrel bolts extended, align female pieces of the barrel bolts and, with four E screws, attach to the coop.
4xD
4xD
11
2xD
2xD
page 7
STEP 6D
10
D
With ladder piece 10 and two B screws attach ladder to nest box entry slot, using pre-drilled holes. (Note for future: if you’re going to reposition this coop around your yard, unscrew and remove ladder first.)
page 8
STEP 7
17
17
16
Drop in all three roost pole pieces 16 into coop so they rest in the roost supports. Slide nest box dividers pieces 17 into slots in both nest box areas.
page 9
STEP 8
B B
BB
BBBB
BB
12
13
14
Using roof pieces 14 and eight B screws, attach the lowest roof sections. (Piece 14 has the wrap-around roof edge and no loose roofing material.) Using roof pieces 13 and eight B screws, attach the middle roof sections. (Piece 13 has overhanging roofing material, which should be positioned over roof piece 14 to prevent water from getting in between the pieces.) Using roof pieces 12 and eight B screws, attach the top roof sections. (Piece 12 has the overhanging roofing material, which should be positioned over roof piece 13, and notched ridge cap edging.)
page 10
STEP 9
CC
15
C
C
Attach ridge cap, piece 15, using four C screws, to roof. You’re done!
