810 Series Bezel Replacement.A

4
Blue Coat ® 510/810 Series Front Bezel Replacement Guide

description

810 Series Bezel Replacement.A

Transcript of 810 Series Bezel Replacement.A

Page 1: 810 Series Bezel Replacement.A

Blue Coat® 510/810 Series Front Bezel

Replacement Guide

Page 2: 810 Series Bezel Replacement.A

Replacing the Plastic Front Bezel on a Blue Coat 510/810Use the following instructions to replace the plastic front bezel on a Blue Coat 510/810.

1. Open up the drop-down front bezel door.

2. Remove the 12 screws from the metal side of the front bezel door. Ensure that you remove the screws on the right last.

3. Remove the plastic front bezel.

Figure 1. There are 12 locations where there are screws; three of the 12 are called out above.

4. Remove the replacement bezel from its box and line it up with the front metal piece.

5. Attach the new bezel with the 12 screws that you removed in Step 2.a. Reattach the screws on the right first.b. Do not overtighten the screws; this can cause the bezel to crack.

6. Insert the model badge (ProxySG, Director, ProxyRA, ProxyAV) into the recessed rectangle on the plastic front panel bezel.

2

Page 3: 810 Series Bezel Replacement.A

Contact Information

Blue Coat Systems Inc. 420 North Mary Ave Sunnyvale, CA 94085-4121 http://www.bluecoat.com/support/[email protected]://www.bluecoat.com

For concerns or feedback about the documentation: [email protected]

Printed in the U.S.A.

Document Number: 231-02947

Document Revision: A.0

Copyright Information

Copyright© 1999-2007 Blue Coat Systems, Inc. All rights reserved worldwide. No part of this document may be reproduced by any means nor modified, decompiled, disassembled, published or distributed, in whole or in part, or translated to any electronic medium or other means without the written consent of Blue Coat Systems, Inc. All right, title and interest in and to the Software and documentation are and shall remain the exclusive property of Blue Coat Systems, Inc. and its licensors. ProxyAV™, CacheOS™, SGOS™, SG™, Spyware Interceptor™, Scope™, RA Connector™, RA Manager™, Remote Access™ and MACH5™ are trademarks of Blue Coat Systems, Inc. and CacheFlow®, Blue Coat®, Accelerating The Internet®, ProxySG®, WinProxy®, AccessNow®, Ositis®, Powering Internet Management®, The Ultimate Internet Sharing Solution®, Cerberian®, Permeo®, Permeo Technologies, Inc.®, and the Cerberian and Permeo logos are registered trademarks of Blue Coat Systems, Inc. All other trademarks contained in this document and in the Software are the property of their respective owners.

BLUE COAT SYSTEMS, INC. DISCLAIMS ALL WARRANTIES, CONDITIONS OR OTHER TERMS, EXPRESS OR IMPLIED, STATUTORY OR OTHERWISE, ON SOFTWARE AND DOCUMENTATION FURNISHED HEREUNDER INCLUDING WITHOUT LIMITATION THE WARRANTIES OF DESIGN, MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL BLUE COAT SYSTEMS, INC., ITS SUPPLIERS OR ITS LICENSORS BE LIABLE FOR ANY DAMAGES, WHETHER ARISING IN TORT, CONTRACT OR ANY OTHER LEGAL THEORY EVEN IF BLUE COAT SYSTEMS, INC. HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

3

Page 4: 810 Series Bezel Replacement.A

231-02947 Revision A.0

4