73647763 Warhammer 40k Skirmish
Embed Size (px)
Transcript of 73647763 Warhammer 40k Skirmish
Warhammer 40k: SkirmishUnofficial Rules
The BasicsIntroduction: Small-scale combat is a recurring desire amongst 40k players. Kill team was a nice addition, but it just isnt the same. Player 1 and Player 2 dont operate in the same way. Necromunda is the bees knees, but it just doesnt work for the non-human (i.e. most) players. The purpose of these rules is to allow 40k players to capture some of the feel of Necromunda, without having to learn a new rule set. As such it will be a blend of Warhammer 40,000 mechanics, with some additional tidbits thrown in for strategy, wow factor and simply because you can in a game with a drastically lower model count. The Basic Overview: In the average Skirmish game, forces will be selected by using a single troop choice and being limited by both a point value and a number of upgrades. Unless you and your opponent both agree before hand, both sides are limited to twenty models each. Each model will for the most part act as an individual, but several allowances are made for play balance and to keep some very predictable tactics less useful (but not useless by far).
Assembling your ForceStep 1. Select the Scope. Each list you make will need to conform to a certain scope. The scope is determined by three variables: point value, upgrade limit and model count. The point value is the number of points your force is allowed to use, this is the same as in regular games of 40k; a typical game is between 150 and 250 points, usually in 50 point blocks. The upgrade limit is special to skirmish. This limit is the number of modifications or upgrades you are allowed in the game. This will be described in greater detail in force selection. A typical game should allow 1 upgrade for every 50 full points allowed. Model count is the number of physical models your force may contain. The usual model count is 20. If you have filled your model count and still have points remaining, you gain unlimited (legal) upgrades to try and fill your point value. If you still cant reach your point value, then either deal with it or choose another force. The second part of the scope is the reinforcement contingent. It will be a second smaller force 1/3rd the size (round off) of the normal scope. Following the same restrictions, and organized as a completely separate list. In most games this bonus force will not be used. It will only be used in certain missions, but having this reinforcement already selected, these missions can be played without extra fuss. Step 2. Force Selection: In your appropriate codex, select a troop choice. In the case where a troop choice consists of more than one unit (such as the imperial guard), pick any unit in that choice as your core selection. You may select any number of un-upgraded models from that unit (within the model count scope). For each upgrade you wish to give the unit, you must use one of your available upgrades (defined in the scope). Upgrading a unit character, a heavy or special weapon, or a transport are all examples of upgrades. Any upgrade that can (or must) be given to the entire unit will only take a single upgrade. Frag grenades, krak grenades, and marks of Chaos are all examples of this type of upgrade. A character may spend an upgrade to select a single weapon or piece of wargear that is more than 10 points in value. Alternatively you may spend an upgrade to grant him 10 points of weapon and wargear piecemeal. A powerfist is an example of the first option, while giving an Ork Nob eavy armour and a choppa is an example of the second. Any traits, doctrines or other forms of army wide upgrade you choose will also take a single upgrade per trait or doctrine. Using a variant list (such an Ork Klan or Lost and the Damned) does not require an upgrade to be spent. Any mandatory upgrades (such as an iron fist squads chimera or a grot mobs slaver) do not require an upgrade. Multiple units: When the number of models in your core unit reaches the minimum unit size you may select another troop choice (unless you have multiple units per troop choice) and begin selecting models from that unit (repeat as needed). Alternatively you can also begin to select single, un-upgraded models from an elites, heavy support or fast attack choice for one upgrade each. These selections may not be vehicles or monstrous creatures (this is pure balance people); an ork loota, space marine assault marine or necron immortal are all examples of this. You may upgrade one of these non-troop models for three upgrade points. An ork loota with a lascannon or space marine assault marine veteran sergeant are examples of this. Mandatory elite upgrades (such as a tyranid warriors weapon symbiotes) do not fall under this category. Now you have your skirmish force.
2 InchesStep 3.) Models as individuals: While it would be simple to let each model be a unit of one, some fairly common problems would arise almost instantly. A heavy bolter would be overkill against the imperial guard because you could only target one model at a time, every grunt would be a sniper to target overpriced sergeants from the get go and leadership boosting items would be useless. To combat this, we have the rule of 2 inches, which makes models within two inches of each other (or in some cases a chain of people two inches apart from each other) in one unit. The rule of 2 inches for shooting. This basically allows (and forces) you to take hits on models within two inches of the model your opponent originally targeted. This can be used to protect your character upgrade by keeping grunts close to him as meat shields. It also means multiple shot weapons can kill more than one person if they are bunched up. The rule of 2 inches for close combat. This aspect of the rule means that you are considered part of close combat, if you are within two inches of a friendly model in base-to-base contact. This also means your charge will be successful if a friendly model is in base to base contact within two inches of your maximum charge range. You may charge a model within 2 of the model you shot at in the shooting phase. The rule of 2 inches for leadership. Any model can use the leadership value of character within 2 inches. Also, this ability may be chained along models no more than 2 inches of each other as if they were a single unit in coherency. This concept of chaining is used in all leadership situations that bring numbers into the equation. For example, determining if you are outnumbered would also use this situation, as would determining if Tyranids are in Synapse or the numbers of Orks for a Mob Size or Power of the Waaagh check. There are no easter eggs in this rule, if you think something is being left out from your codex, then bring it up with your opponent before hand and let him know youre including it.
Step 4.) Descriptive Interlude.With the above rules you could easily play a game of warhammer 40,000 skirmish. The game however would get stale pretty quickly. In necromunda there are no range penalties to moving and shooting, and since you are squaring off against other humans it isnt suicidal to move into close combat with them. Using only the rules above there would be no reason for Tau Firewarriors to do anything but form a gunline and pray for victory against an approaching swarm of Genestealers, thus we need some rules too complicated for larger scale battles to spice things up.
Step 5.) New rules: Shooting
First off, a few new (and old) rules are coming back. Yes that means there will be a simplified form of overwatch so lets start with this most holy and yet most contentious of rules. As a side note, you may wish to have a models base block line of sight to other models (friendly or enemy). This may make the game more real but it can also lead to some quite un-fun meta-gaming. So restrict it to opponents you trust not to try such things. Overwatch: Going on overwatch represents your soldier, huddling down and gripping his gun with white knuckles, just waiting for that genestealer to bust around the corner. The second he does bust around the corner the soldier is going to unload everything he has on it. Overwatch works as follows: Nominate any of your models to go on overwatch during your shooting phase. If he has not moved, he automatically goes on overwatch. If he has moved, he must make a leadership check, if he fails, his turn is done. A model on overwatch may take no further actions for the turn. The fun begins on your opponents turn, during the shooting phase. At the beginning of your opponents shooting phase, nominate a model on overwatch and roll a d6. If the result is equal to or lower than its initiative (a 6 always fails) you may make its shooting attack immediately but ONLY at the closest target. Units with Fleet may use this movement to move towards the nearest enemy unit. If they move into base-to-base contact with the nearest target, they count as charging it. Models that failed their initiative check will get to shoot at the end of the opponents turn, after the assault phase. The purpose to this rule is to prevent some units from completely dominating in closed quarters. The purpose of the allowing units with fleet to charge is to prevent melee units from being terrible in closed quarters, since more terrain will be prevalent Spray and Pray: Any model which has a rapid-fire weapon can choose to Spray and Pray rather than shooting normally. The model is considered to be rapid-firing for all intents and purposes when it comes to assaulting after. The benefit is that two shots may be fired 24 instead of the usual 12. The downside is that these shots will only hit on a 6 and that target will receive and additional +1 to their cover save if they have one. The purpose of this rule is to give an option to Joe guardsman besides forming a gun line, without making him unstoppable to melee forces. Movement is to be encouraged.
Shooting, ContinuedFrag and Plasma Grenades: