SAP Note

Header Data

Symptom

This note concerns error analysis in the network environment and CPIC return codes in particular. The meaning of the return code numeric values is unclear.

Other Terms

Error, return codes, SAP-RC, CPIC-RC

Reason and Prerequisites

Solution

CPIC return codes (not SAP-specific)

CM_OK0 CM_ALLOCATE_FAILURE_NO_RETRY1 CM_ALLOCATE_FAILURE_RETRY2 CM_CONVERSATION_TYPE_MISMATCH3 CM_SECURITY_NOT_VALID6 CM_SYNC_LVL_NOT_SUPPORTED_PGM8 CM_TPN_NOT_RECOGNIZED9 CM_TP_NOT_AVAILABLE_NO_RETRY10 CM_TP_NOT_AVAILABLE_RETRY11 CM_DEALLOCATED_ABEND17 CM_DEALLOCATED_NORMAL18 CM_PARAMETER_ERROR19 CM_PRODUCT_SPECIFIC_ERROR20 CM_PROGRAM_ERROR_NO_TRUNC21 CM_PROGRAM_ERROR_PURGING22 CM_PROGRAM_ERROR_TRUNC23 CM_PROGRAM_PARAMETER_CHECK24 CM_PROGRAM_STATE_CHECK25 CM_RESOURCE_FAILURE_NO_RETRY26 CM_RESOURCE_FAILURE_RETRY27 CM_UNSUCCESSFUL28 CM_OPERATION_INCOMPLETE35 CM_SYSTEM_EVENT 36

Gateway error codes

CPIC_ERROR221 Error in the CPIC interface CANT_GET_MEMORY222 Memory bottleneck NI_READ_FAILED223 Network read error NI_WRITE_FAILED224 Network write error INVALID_REQUEST225 Invalid request NOT_YET_CONNECTED226 Not yet connected GW_WP_DIED227 Gateway process died SHM_READ_FAILED228 Shared memory problem (read) SHM_WRITE_FAILED229 Shared memory problem (write) NO_MORE_LU230 No available LU NO_MORE_WP231 No available gateway process CANT_START_WORKPROCESS232 Error when starting the gateway process WRONG_COMM_TYPE233 Wrong communication type CONNECT_FAILED234 Connection setup failed COMM_TABLE_ERROR235 Error in comm. table GW_CONNECT_FAILED236 No connection to the gateway GW_DISCONNECTED237 Connection to the gateway disconnected WRITE_TO_GW_FAILED238 Error with GW comm. (write) READ_FROM_GW_FAILED239 Error with GW comm. (read) INVALID_LEN240 Invalid length INVALID_ENVIRONMENT 241 Invalid environment GW_TIMEOUT242 Timeout GW_CONNECT_TO_R3243 Error when setting up R/3 connection SYSTEM_DISCONNECTED244 Partner disconnected connection

63347 - List: CPIC error codes

Version 11 Validity: 26.11.2008 - active Language English

Released On 01.12.2008 08:13:48 Release Status Released for Customer Component BC-CST-GW Gateway/CPIC

BC-NET Network Infrastructure

Priority Recommendations / Additional Info Category Help for error analysis

Other Components

MEM_OVERFLOW245 Memory overflow WRONG_APPCHDR_VERSION 246 Incorrect APPC header version GW_APPC_SERVER_DOWN247 Loc. gateway not started TXCOM_TABLE_FAILED248 Error when accessing TXCOM COMM_TABLE_OVERFLOW 249 Comm. table full C_NO_MEM450 No memory C_NO_SIDE_INFO451 No SIDE INFO entry C_TP_START452 TP-START failed C_NO_INIT453 No initialization C_GETLU454 "getlu" failed C_SIGNAL455 "signal" failed C_TIMEOUT456 Timeout when establishing connection C_ALLC457 CMALLC failed C_SEND458 CMSEND failed C_PREPARE459 Prepare-To-Receive failed C_FLUSH460 CMFLUS failed C_RECEIVE461 CMRCV failed C_NO_ARGUMENT462 Missing argument C_GET_ALLOCATE463 "get_allocate" failed C_DEAL464 CMDEAL failed C_TP_END465 TP-END failed C_MAX_CONV466 Max. number conv. reached C_SNAOPEN467 "snaopen" failed C_SNACTL468 "snactl" failed C_NO_FLUSH469 No flush in IBM environment C_SNACLSE470 "snaclse" failed C_STATE_CHECK471 Status error C_NO_SIDE_INFO_ENTRY472 No side info entry C_NO_CONV473 No conversation C_MANUAL_CANCELD474 Connection manually cancelled C_AUTO_CANCELD475 Connection automatically cancelled C_NO_PARTNER476 No partner found C_CONFIRM477 Confirm failed C_CONFIRMED478 Confirmed failed C_NO_HOST_IN_SIDE_INFO479 GWHOST not in side info entry C_NO_SERV_IN_SIDE_INFO480 GWSERV not in side info entry C_NO_PROT_IN_SIDE_INFO481 PROTOCOL not in side info entry C_NO_LU_IN_SIDE_INFO482 LU not in side info entry C_NO_TP_IN_SIDE_INFO483 TP not in side info entry C_NO_GATEWAY_CONNECTION 484 No connection to the gateway C_GETHOSTNAME485 gethostname failed C_NO_SAP_CMACCP486 SAP_CMACCP not executed C_NO_PROGRAM_NAME_ARG 487 Program not in arg. list C_NO_HOST_ARG488 Host not in arg. list C_NO_SERV_ARG489 Service not in arg. list C_NO_CONVID_ARG490 Conv. ID not in arg. list C_ILLEGAL_PARAMETER 491 Illegal parameter C_LU62CVCT492 LU62CVCT failed C_LU62ATTACH493 LU62ATTCH failed C_NO_CONV_TABLE494 No conv. table C_ILL_CONV_TABLE495 Incorrect conv. table C_ILL_MOD_VALUES496 Invalid conv. modification C_NIHOSTTOADDR497 NiHostToAddr failed C_NIADDRTOHOST498 NiAddrToHost failed C_THOST_FAILED499 Reading table THOST failed INVALID_MODE630 Invalid mode number received MAX_NO_OF_GATEWAYS631 Max. no. of gateways reached MISSING_LU_SPEC632 No LU specified MAX_CPIC_CLIENTS633 Max. no. of clients reached BAD_TPNAME634 Invalid TP name FORK_FAILED635 Fork failed BAD_NI_HANDLE636 Invalid NI handle REXEC_FAILED637 rexec failed TP_START_FAILED638 Starting the TPs failed NI_DG_SEND_FAILED639 NiDgSend failed INTERNAL_ERROR640 Internal error GW_HOST_UNKNOWN664 Gateway host unknown GW_SERVICE_UNKNOWN665 Gateway service unknown GW_NI_ERROR666 NI error GW_EXEC_FAILED667 exec failed R2_RESTARTED668 R/2 restarted SYM_DEST_TOO_LONG669 Symb. destination too long NO_MORE_SIDE_INFO_ENTRY 670 No more side info entries R3_LOGIN_FAILED672 R/3 Login failed IMS_ERROR_PURGING673 IMS error purging PENDING_TERM_OUTPUT674 Timeout of reg. programs GW_SECURITY_ERROR676 TP not registered GW_TIMEOUT_REG_PRGM677 Timeout of registered program TP_REGISTERED678 TP is registered TP_NOTREGISTERED679 TP not registered TP_REG_SECU_ERROR720 Security violation for reg. prgrms GW_SNC_DISABLED721 SNC deactivated GW_SNC_REQUIRED722 SNC required GW_SNC_NAME_NOT_SET 723 SNC name not defined GW_SNC_NAME_NO_DEFAULT724 Default SNC name not permitted GW_SNC_PROT_NOT_SUPP725 Log does not support SNC GW_R3_NOT_CONNECTED726 No local R/3 system GW_SNC_REQUIRED_FOR_LU_TP 727 SNC required CONV_ID_NOT_FOUND728 Conversation ID not found GW_SNC_SECURE_PORT729 Comm. must make SNC

GW_SNC_START_EXT_DIS730 Start of ext. Program deactivated GW_SHUTDOWN731 Gateway was shut down GW_REM_PRGM_DISABLED732 No external programs GW_STOLEN_CONVID733 Conversation ID does not fit GW_NET_CONV_ERROR 734 Net Conv Error GW_MONITOR_DISABLED 735 Monitor not active GW_DUPLICATE_CVID736 Conv. ID not unique GW_CONNECT_TIMEOUT737 Timeout of connection setup to remote system GW_REQ_TO_DP_FAILED738 Request could not be transferred to the dispatcher GW_CLIENT_ALREADY_DISC739 Connection partner has already disconnected the connection GW_NO_HOST_IN_ROUTE 740 No hosts contained in route ..GW_ROUTE_CONNECT_DIS741 Route already disconnected (no longer used) GW_CONN_IS_FREE742 Connection already released GW_CONN_IS_DISC743 Connection disconnected GW_REQBLK_ADM_ERROR 744 Error in request processing GW_BUFINFO_ERROR745 Error in buffer handling GW_HDLINFO_ERROR746 Error in network handling TP_REG_NOREG_ERROR747 Number of registrations exceeded for this program TP_REG_ACCESS_DENIED748 Access to registered server denied GW_PARAM_NOT_FOUND749 Parameter could not be found GW_PRXY_ACCESS_DENIED 750 Gateway must not be used as a proxy GW_ACCEPT_TIMEOUT751 Timeout when logging on (gw/accept_timeout) GW_WRONG_SERVER752 not connected to the gateway C_NO_SIDE_INFO_GW760 No side info file C_RECEIVE_WITH_PAR761 CMRCV failed C_NO_SNC_LIB_ARG762 SNC library not in arg. list C_NO_SNC_NAME_ARG763 SNC name not in argument list C_SNC_INV_HANDLE764 SNC invalid handle C_SNC_DISABLED765 SNC deactivated C_SNC_ERROR766 General SNC error C_SNC_MODE_ON767 SNC required C_SNC_NOT_AVAILABLE 768 SNC not available C_ILLEGAL_PARAMETER2769 Invalid parameter C_AREA_TOO_SMALL770 Memory area too small C_SNC_INV_STATE771 Invalid SNC status C_RETURN_CODES772 Error numbers C_REG_STATE_CHECK773 Status violation during registration C_CPICTERR774 Error text for error number C_NO_SYMDEST775 No symbolic destination C_FUNCTION_NOT_SUPPORTED776 Function not supported C_NET_CONV_ERROR777 Conversion error when reading or writing data C_SIDEINFO_DISABLED778 Access to side info file deactivated C_TIMEOUT_BLOCK779 Timeout for blocking network call C_FAILOVER_ERROR780 Error when communicating with failover software C_PROXY_ERROR781 Error when communicating with the proxy server C_MPI_ERROR782 Error when communicating with memory pipes (Mpi) C_MTX_ERROR783 Error with lock management (mutex) C_CS_ERROR784 Error with lock management (critical section)

Validity

This document is not restricted to a software component or software component version

References

This document refers to:

SAP Notes

This document is referenced by:

SAP Notes (10)

446172 SXPG_COMMAND_EXECUTE (program_start_error) in DB13 320991 Error codes during logon (list) 308929 Activating trace for SAP Logon Control 116051 Checklist: Problems SNA gateways (R/3 ==> R/2)

64016 Using the SAP Gateway monitor GWMON 63342 List: NI error codes 42692 Test tool for RFC links: sapinfo 34998 Checking on OS level whether R/3 is running

557132 CC-TOPIC: Remote client copy 446172 SXPG_COMMAND_EXECUTE (program_start_error) in DB13 308929 Activating trace for SAP Logon Control 320991 Error codes during logon (list) 63342 List: NI error codes 64016 Using the SAP Gateway monitor GWMON 116051 Checklist: Problems SNA gateways (R/3 ==> R/2) 116787 CC-TOPIC: Remote client copy

34998 Checking on OS level whether R/3 is running 42692 Test tool for RFC links: sapinfo