4 Post Shelving Reference Shelf Installation Instructions
Click here to load reader
-
Upload
installation-manuals-southwest-solutions-group -
Category
Business
-
view
56 -
download
1
Transcript of 4 Post Shelving Reference Shelf Installation Instructions
REFERENCE SHELF INSTALLATION INSTRUCTIONSStep1Locate two shelf supports positioned at the desired height.
Step 2Extend plated slides out back of shelf and bolt z-shaped mounting bracket through mating round holes in slide and bracket with nut on bottom. Use two 8-32 x 3/8" bolts and nuts on each slide. Flange with slots should face up and out from end of shelf. 'Z' brackets are double punched to eliminate lefts and rights. See Figures 2 and 3 for correct bolting for your unit depth. Front two holes in plated slide are located by moving slide access hole over mounting hole.
Step 3Hold reference shelf with slides retracted beneath it under the shelf supports so that mounting bracket slots are lined up just beneath four holes in shelf supports and bolt with four 10-24 x 5/8" bolts and four nuts on bottom. Front of mounting bracket should be even with front face of shelf support.
Step 4Place fixed standard shelf over shelf supports. When fully closed, reference shelf should be flush with front of fixed shelf above it. If reference shelf does not retract to proper location, you have used the wrong holes in bolting plated slides to mounting brackets.
Slide extends out back ofreference shelf and bottom
slide member boltsto mounting bracket
Front shelf support
Rear shelf support
MountingBracket
Reference shelf has twoplated slides riveted to it
WARNING: REFERENCE SHELFCAPACITY MAX 50 LBS.
Page 1 INS
T007
6R
EV
1TJ
E10
/1/0
4
10-24 x 5/8" Phillips PanHead Machine Screw
8-32 x 3/8" Phillips PanHead Machine Screw
8-32 Hex Nut
10-24 Hex Nut
Standard shelf is used above referenceshelf and fits over same pair of shelf
supports as reference shelf mounts to.
www.southwestsolutions.com
8-32 Hex Nut
8-32 x 3/8" Phillips PanHead Machine Screw
Mount Bracket
Plated Slide
Rear of Reference Shelf
Mount Bracket
Plated Slide
Rear of Reference Shelf
Use these slots tomount to support brackets
Use mating holes shown for12", 15", & 18" deep units.
Use mating holes shown for24", 30", & 36" deep units.
Another reference shelf can bemounted here on same
mounting brackets in 24", 30", &36" double entry units if desired.
Page 2
**Units shown upside down for clarity**
Another reference shelf can bemounted here on same mountingbrackets in 24", 30", & 36"double entry units if desired
www.southwestsolutions.com