3M™ Fiber Outdoor Network Interface Device170 mm x 240 mm NID-FO-1724-AT: One SC/APC Adapter and Fiber Splice Tray

NID-FO-1724-ATF: One 3M™ Fibrlok™ Splice, SC/APC Pigtail and Fiber Splice Tray

Instructions

December 201578-0015-1786-7-C

Fusion splice holder for two optional fusion protection sleeves

Mounting hole locations Aerial Drop Cable Application1. Strip network drop cable down to buffer tube,

63 inches.

2. Poke a hole through the grommet.

3. Secure the drop cable to the box.

Buried Drop Cable Application with 0.5-inch Conduit1. Strip network drop cable down to buffer tube,

63 inches.

2. Cut hole in rubber grommet for 0.5-inch conduit, and secure conduit to box.

3. Secure the drop cable with cable clamp (Cable clamp not supplied with box).

Note: The remaining steps are the same for both aerial and buried applications.

4. Loop the white buffer tube two times.

5. Strip the buffer tube off to expose 250 μm fiber, 21.0 inches.

6. Secure the buffer tube.

7. Loop 250 µm fiber into the slack storage area of the splice tray.

8. Strip and cleave 250 µm fiber. Cleave length is 12.5 (0.5 in).

Fusion splice holder for two optional fusion protection sleeves

3M™ Fibrlok™ Splice Holder

9. Insert 250 µm fiber into the 3M™ Fibrlok™ Splice.

10. Make sure both fiber ends are in contact inside the 3M Fibrlok Splice.

11. Push activator bar to activate the 3M Fibrlok Splice.

2 78-0015-1786-7-CDecember 2015

12. Place cover onto the splice tray by snapping the tabs into place.

13. Poke a hole through the grommet and secure the premises drop cable.

14. Plug cable into the adapter. Coil excess premises cable and secure to inside of box.

Note: This product is not intended to be used with pre-terminated outside drop cable.

378-0015-1786-7-C December 2015

Communication Markets Division6801 River Place Blvd.Austin, TX 78726-9000

Phone 1-800-426-8688Web www.3M.com/Telecom

Please recycle. Printed in USA © 3M 2015. All rights reserved. 78-0015-1786-7-C

3M and Fibrlok are trademarks of 3M Company. All other trademarks used herein are properties of their respective companies.

Important NoticeAll statements, technical information, and recommendations related to 3M’s products are based on information believed to be reliable, but the accuracy or completeness is not guaranteed. Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability associated with such use. Any statements related to the product which are not contained in 3M’s current publications, or any contrary statements contained on your purchase order shall have no force or effect unless expressly agreed upon, in writing, by an authorized officer of 3M.

Warranty; Limited Remedy; Limited Liability. This product will be free from defects in material and manufacture for a period of one (1) year from the time of purchase. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the warranty period stated above, your exclusive remedy shall be, at 3M’s option, to replace or repair the 3M product or refund the purchase price of the 3M product. Except where prohibited by law, 3M will not be liable for any direct, indirect, special, incidental or consequential loss or damage arising from this 3M product, regardless of the legal theory asserted.