2D Studies Highlights

2D Studies Exterior & Interior Highlights

Ford Fiesta 1.6 TDCI Titanium

CONTENTS

• Exterior highlights Page 2-3

• Interior highlights Page 4-5

• Carry over Page 6

• Planning Page 7

CONTACTSFrance25 Chaussée de Hary02140 VervinsTel : 33(3) 23 98 49 66Fax : 33(3) 23 98 55 91

Project managers : Pierre Yves Moulière – pmouliere@a2mac1.comJean Marie Moulière – jmouliere@a2mac1.com

2D Studies manager :Gregory Cordelette – gcordelette@a2mac1.com

USA3901 Bestech road. Suite 100Ypsilanti, MI 48197Tel : 001 734 973 6468Fax : 001 734 973 6475

-Exterior highlights :

• Absence of pressure piece between the fender and front bumper is uncommon.( see section 03 ) :

• The scuttle grille includes the hood seal by co-moulding process ( see section 07 ):

• The windshield includes a defrosting system (see section 07 & 22 ) :

2D Studies Highlights

• The third stop light has a light diffuser, this same system is found on the RENAULT MEGANE (see section 09 ) :

• The drip moulding has no garnish on the beginning or the end of part, it is cut after extrusion (see section 13) :

• Padding in EPP present in the lower area of the door (see section 28) :

• The optional roof bar attaching system can create a corrosion point if the mounting is not correctly effected (see section 13) :

2D Studies Highlights

• USB & jack plug modulus on central consol (see section 20) :

• Lighting device present in the storage compartment on the instrument panel central front side in the form of a light band (see section 8) :

2D Studies Highlights

• Presence of knee airbag in driver area (voir section 03) :

-Interior highlights :

• Lighting device present on the upper area of the passenger glovebox in the form of a light band (voir section 12) :

2D Studies Highlights

- Carry over :

2D Studies Highlights

• Rear wiper motor :

Ford fiesta Ford galaxy Ford kuga

• Trunk lid exterior opening control :

Ford fiesta Ford galaxy

• Front roof light modulus :

• Instrument panel lateral airvents :

Ford kuga Ford mondeo

Ford fiesta Ford kuga Ford mondeo

Ford fiesta Ford galaxy Ford mondeo

-Planning :

We are currently working on the AUDI Q5, this car will be finished in week 25.

The next vehicle to be studied will be the LEXUS RX 350 in parallel with the VOLKSWAGEN GOLF 6.

If you have any questions, commentaries or other demands, please do not hesitate to contact me.

Best regards,

Grégory Cordelette

Best regards,

A2Mac1 – Automotive Benchmarking 25 Chausée de Hary02140 HARY – FRANCE

Phone: +33 3 23 98 89 26Fax: +33 3 23 98 55 91Mail: gcordelette@a2mac1.comSkype: gcordelette_a2mac1

2D Studies Highlights