2211 E Indian School Rd, Phoenix, AZ 85016 Phone: 602-840-4205

2015 and Later Road Glide Power Amp Installation

Remove seat, fuel tank, windshield, outer fairing, and headlamp assembly as per the instructions in your Harley Davidson service manual.

Disconnect negative battery cable.

Remove wire harness tray cover.

Route 8AWG power and ground cable through tray. Also, if installing rear speakers route rear speaker harness through tray.

Main fuse holder should be in front of battery for ease of accessibility.

Main cables can run along left side of neck; pull them through to front of the inner faring.

Using one of the supplied rear amp connectors from Rockford, crimp to rear speaker leads.

Cut, strip, and install the 8AWG cables to the Power amp connector.

Connect blue trigger wire from (299A conn.) to REM terminal.

Extend front speaker lead with a portion of white and gray wire from the wire kit.

Crimp socket terminals to wire end and push into connector. At this connection positive and negative polarity should be reversed (See speaker install for reason).

ATTENTION: Do not break tap! Be careful.

Using a 10-32 bottoming tap, tap the center mount bung on front of radio. At this time, tap amp plate with 8-32 tap, mount amp to plate. Connect speaker outs and power connector in and slide

amp plate into position under radio hooking frame with amp plate ears and install 10-32 screw with washer and tighten. You can apply a small amount of blue 242 Loctite to threads.

Using terminals and connectors from auxiliary connector kit, crimp terminals to front input amp connector lead and push into 2 pin connector.

Make sure to lock terminals with lock white/white with black stripe to left side and gray/gray with black stripe to right side front inputs.

If installing 4 channel input, use rear input connector harness from Rockford violet with violet black to right side and green with green back colors to left side.

Crimp terminals and push wires into 4 pin connector (rear output from head unit). Connect these to amp.

Must flash head unit as per Rockford instructions (1.9 version as of July 2015). Tune amp to Rockford specifications (tune card with amp).

Install headlamp assembly, outer fairing, windshield, fuel tank, and seat. Enjoy your new sound!