2013IEEE POWER ELECTRONICS PROJECT

TITLES

BOOST CONVERTER1 Analysis, design, and performance evaluations of an edge-resonant switched

capacitor cell-assisted soft-switching PWM boost dc–dc converter and its

interleaved topology

2 DCM analysis and inductance design method of interleaved boost converters

3 Interleaved boost converter with ripple cancellation network

4 Interleaved high step-up ZVT converter with built-in transformer voltage doubler

cell for distributed PV generation system

5 Reduced-order model and control approach for the boost converter with a voltage

multiplier cell

BOOST RECTIFIER1 Adaptive dead-times compensation for grid-connected PWM inverters of single

stage PV systems

2 Improved voltage-vector sequences on dead-beat predictive direct power control of

reversible three-phase grid-connected voltage-source converters

3 Nonlinear behaviors and instability in a three-phase boost rectifier connected to a

non-ideal power grid with an interacting load

4 The Taipei rectifier—a new three-phase two-switch ZVS PFC DCM boost rectifier

BUCK CONVERTER1 A dc–dc converter based on the three-state switching cell for high current and

voltage step-down applications

ECWAY TECHNOLOGIESIEEE PROJECTS & SOFTWARE DEVELOPMENTS

OUR OFFICES @ CHENNAI / TRICHY / KARUR / ERODE / MADURAI / SALEM / COIMBATORE

BANGALORE / HYDRABAD

CELL: +91 98949 17187, +91 875487 1111 / 2111 / 3111 / 4111 / 5111 / 6111 / 8111

VISIT: www.ecwayprojects.com Mail to: ecwaytechnologies@gmail.com

2 A high step-down transformerless single-stage single-switch ACDC converter

3 Interleaved boundary conduction mode (BCM) buck power factor correction (PFC)

converter

4 Light-loads efficiency improvement in buck-derived single-stage single-switch PFC

converters

5 Series asymmetrical half-bridge converters with voltage auto balance for high

input-voltage applications

DC-DC CONVERTER1 Adaptive voltage control of the DCDC boost stage in PV converters with small input

capacitor

2 High-efficiency single-input multiple-output dc–dc converter

3 Soft-switching dc-dc converter with a full ZVS range and reduced output filter for

high-voltage applications

4 Unterminated small-signal behavioral model of dc–dc converters

INDUCTION HEATING1 Mutual impedance of small ring-type coils for multiwinding induction heating

appliances

INVERTER1 A single-phase grid-connected fuel cell system based on a boost-inverter

2 Mitigation of lower order harmonics in a grid-connected single-phase PVinverter

LED DRIVE1 A new control method of interleaved single-stage fly back AC–DC converter for

outdoor led lighting systems

2 An adaptive output current estimation circuit for a primary-side controlled led

driver

3 Electric equivalent model for induction electrode-less fluorescent lamps

4 High-efficiency asymmetrical half-bridge converter without electrolytic capacitor

for low-output-voltage ac–dc led drivers

5 Light-to-light PV-fed led lighting systems

MOTOR DRIVES1 A current controller design for current source inverter-fed ac machine drive system

2 Improved sensor-less operation of a CSI-based induction motor drive long feeder

case

3 Common-mode voltage reduction methods for current-source converters in

medium-voltage drives

4 Precise accelerated torque control for small inductance brushless dc motor

5 Problems incurred in a vector-controlled single-phase induction motor, and a

proposal for a vector-controlled two-phase induction motor as a replacement

MULTILEVEL INVERTER1 Asymmetric control of dc-link voltages for separate MPPT’s in three-level inverters

2 Multilevel dc-link inverter and control algorithm to overcome the PV partial

shading

POWER FACTOR CORRECTION1 Digital plug-in repetitive controller for single-phase bridgeless PFC converters

2 High power factor ac–dc led driver with film capacitors

3 Input differential-mode EMI of CRM boost PFC converter

4Perturbation on-time (pot) technique in power factor correction (PFC) controller

for low total harmonic distortion and high power factor

5Triple loop modulation (TLM) for high reliability and efficiency in a power factor

correction (PFC) system

RENEWABLE ENERGY

1A high step-up converter with a voltage multiplier module for a photovoltaic

system

2A new dc anti-islanding technique of electrolytic capacitor-less photovoltaic

interface in dc distribution systems

3 A single-phase grid-connected fuel cell system based on a boost-inverter

4An optimal control method for photovoltaic grid-tied-interleaved fly-back micro-

inverters to achieve high efficiency in wide load range

5Analysis, design, and experimental results of a novel soft-switching snubber-less

current-fed half-bridge front-end converter-based PV inverter

6Application and stability analysis of a novel digital active EMI filter used in a grid-

tied PV micro-inverter module

7Design and implementation of energy management system with fuzzy control for

dc micro-grid systems

8 Design optimization of transformer-less grid-connected PV inverters including

reliability

9Design, analysis, and implementation of solar power optimizer for dc distribution

system

10Development and operational control of two-string maximum power point trackers

in dc distribution systems

11Dual transformer-less single-stage current source inverter with energy

management control strategy

12 Grid interfacing of multi-megawatt photovoltaic inverters

13Integration and operation of a single-phase bidirectional inverter with two

buck/boost MPPT’s for dc-distribution applications

14Modeling and simulation of all-electric ships with low-voltage dc hybrid power

systems

15Novel energy conversion system based on a multimode single-leg power

converter

16Origin of cross-coupling effects in distributed dc–dc converters in photovoltaic

applications

17 Reconfigurable solar converter a single-stage power conversion pv-battery system

18Synchronous-reference-frame-based control of switched boost inverter for

standalone dc Nano-grid applications

19 Synthesizable integrated circuit and system design for solar chargers

RESONANT CONVERTER1 Analysis of a fifth-order resonant converter for high-voltage dc power supplies

2 Design methodology for a very high frequency resonant boost converter

3 Hybrid-frequency modulation for PWM-integrated resonant converters

SEPIC CONVERTER1 Bridgeless SEPIC converter with a ripple-free input current

STATCOM

1Adaptive theory-based improved linear sinusoidal tracer control algorithm for

dstatcom

UNINTERRUPTIBLE POWER SUPPLY (UPS)

1A high-performance SPWM controller for three-phase ups systems operating

under highly nonlinear loads

2 Battery / super capacitors combination in uninterruptible power supply (ups)

WIND ENERGY

1Control of improved full-bridge three-level DCDC converter for wind turbines in

a dc grid

2Dc-voltage fluctuation elimination through a dc-capacitor current control for

DFIG converters under unbalanced grid voltage conditions

3Analysis and comparison of medium voltage high power DCDC converters for

offshore wind energy systems

4Enhanced control of a DFIG-based wind-power generation system with series

grid-side converter under unbalanced grid voltage conditions

Z SOURCE INVERTER1 Cascaded multicell trans-z-source inverters

2Generalized multicell switched-inductor and switched-capacitor z-source

inverters

3Improved trans-z-source inverter with continuous input current and boost

inversion capability

4 Space-vector-modulated three-level inverters with a single z-source network

BATTERY CHARGER1 Synthesizable integrated circuit and system design for solar chargers

2Zero no-load power ACDC adapter for electronic equipment with embed

battery