2 Pultrusion BH-2 (4)
-
Upload
amir-kadic -
Category
Documents
-
view
91 -
download
0
Transcript of 2 Pultrusion BH-2 (4)
Doo P U L L E D C O M P O S I T E S
THE PULTRUSION TECH
Rel. 1.0 The pultrusion 1
26/09/2013
THE PULTRUSION
PULTRUSION is a continuous process for
producing composite constant section
profiles made with structural fibers suitably
oriented, bonded with a polymeric matrix.
By varying the fibers type or direction, or the
used matrix, noticeable variations can be
achieved in the chemical and or physical
properties of the product, so making it
suitable to the request.
Rel. 1.0 The pultrusion 2
26/09/2013
The PULTRUSION process starts when the
reinforcing fibers pass through an impregnating
bath where they come in contact with the fluid
resin.
Following this, the impregnated fibers are
carefully guided through appropriate stations to
the die entrance, where the polymerisation
process is activated by high temperature.
Rel. 1.0 The pultrusion 3
26/09/2013
It's important to underline that the
polymerisation process is fully completed
before the exit of the die, making the
process a 'closed-mould' process, so
reducing any volatile emission and assuring a
very elevated grade of curing. This permits
to obtain high chemical and physical
properties and a very limited ambient impact.
Rel. 1.0 The pultrusion 4
26/09/2013
The relatively low cost of the dies (moulds )
necessary to realize a pultrused profile let to
size and realize the same profile in function of
the specific scope.
Is possible optimize the weight of the profile
and so reduce the costs, eventually
integrating more functions and let possible a
good cost/benefit ratio.
Can be pultruded also complex profile section
objects to maximize the benefits of a 'custom
tailored' project.
The profiles are done in continuous and in
every length compatible with transportation
( some profiles of small dimensions can be
rolled up).
Rel. 1.0 The pultrusion 5
26/09/2013
PULLCOM has several lines of pultrusion and
some hundred dies.
For its lines dimensions, it can produce big
structural profiles, which drawing is in a
rectangle of about 100x30 cm.
It has several equipments for special
productions and post-production on request by
the customer
Rel. 1.0 The pultrusion 6
26/09/2013
Rel. 1.0 The pultrusion 7
26/09/2013