2-Band 9 volt or 18 volt Preamp/Tone control
2
PICKUPS AND ELECTRONICS Treble 50KΩ Linear Bass 50KΩ Linear Blend Dual 250KΩ 5A5C The NTBT-918 is a tone control preamp with fully independent Bass and Treble controls with very low noise and wide boost/cut range. The sound is extremely clear and transparent. Distortion is well below 0.001%. This preamp can be used with either a single 9 volt battery ( 9 volt operation) or two 9 volt batteries (18 volt operation) which yields 6dB extra headroom. 2-Band 9 volt or 18 volt Preamp/Tone control NTBT-918 In 9 volt operation the NTBT-918 uses approximately 750 microamperes of current from 1 - 9 volt battery. This means 1 month of continuous duty or more than 6 months of average usage. In 18 volt operation the NTBT-918 uses approximately 1000 microamperes of current from 2 - 9 volt batteries. This means more than 3 weeks of continuous duty or more than 4 months of average usage. The negative side of the battery(ies) should be connected to the jack ring so that power is turned on only when the plug is in. Unplug the instrument when not in use to conserve your battery. 9 volt OR 18 volt black Bridge Pickup Neck Pickup blue grey white green yellow 2.7KΩ 10KΩ Gain The NTBT-918 features an adjustable gain which allows you to boost the input signal up to 12dB while maintaining flat frequency response. Vol 25KΩ Audio green black black black red Gain Bass Treble Out Gain Battery+ Ground DO NOT USE MORE THAN 18 VOLT SUPPLY VOLTAGE OR EXTERNAL POWER SUPPLIES In R171015.1 Response Bass Mid Treble NTBT +/-15dB@30Hz Center@400Hz +/-16dB@6KHz
Transcript of 2-Band 9 volt or 18 volt Preamp/Tone control
PICKUPS AND ELECTRONICS
Treble50KΩLinear
Bass50KΩLinear
BlendDual
250KΩ5A5C
The NTBT-918 is a tone control preamp with fully independent Bass and Treble controls with very low noise and wide boost/cut range. The sound is extremely clear and transparent. Distortion is well below 0.001%.This preamp can be used with either a single 9 volt battery ( 9 volt operation) or two 9 volt batteries (18 volt operation) which yields 6dB extra headroom.
2-Band 9 volt or 18 volt Preamp/Tone control
NTBT-918
In 9 volt operation the NTBT-918 uses approximately 750 microamperes of current from 1 - 9 volt battery. This means 1 month of continuous duty or more than 6 months of average usage. In 18 volt operation the NTBT-918 uses approximately 1000 microamperes of current from 2 - 9 volt batteries. This means more than 3 weeks of continuous duty or more than 4 months of average usage.The negative side of the battery(ies) should be connected to the jack ring so that power is turned on only when the plug is in. Unplug the instrument when not in use to conserve your battery.
9 voltOR
18 volt
black BridgePickup
NeckPickup
blu
egr
ey
wh
ite
green
yellow2
.7KΩ
10KΩ
Gain
The NTBT-918 features an adjustable gain which allows you to boost the input signal up to 12dB while maintaining flat frequency response.
Vol25KΩAudio
green
black
black
blackred
Gai
n
Bas
s
Treb
le
Ou
t
Gai
nB
atte
ry+
Gro
un
d
DO NOT USE MORE THAN 18 VOLT SUPPLY VOLTAGE OR EXTERNAL POWER SUPPLIES
In
R171015.1
Response Bass Mid Treble
NTBT +/-15dB@30Hz Center@400Hz +/-16dB@6KHz
PICKUPS AND ELECTRONICS
Vol250KΩAUDIO
B/TStacked
50KΩLinear
BlendGanged 250KΩ5A5C
Vol250KΩAUDIO
Active/Passive Wiring as on “AP” Harnesses HR-3.3AP and HR-4.5AP
NTBT-918
black BridgePickup
NeckPickup
green
green
yellow
Stacked Bass/Treble as on HR-2.2 and HR-3.3
Bass
black NeckPickup
BridgePickup
Vol250KΩAUDIO
Vol250KΩAUDIO
green
yellow
Active/Passive Wiring as on HR-4.2AP Harness
yello
w
Treble
Configuration Options on Standard Pre-Wired Harnesses
Single Pickup Active/Passive Wiring as on HR-2.2AP and HR-2.3AP Harness
Ground – Connected to preinstalled bare wire. Connect to cavity shield if available. Also ensure bridge is connected to ground.
blackSinglePickup
green
yellow
R150722.1
