1

Recognize Any Hazard(s)?Recognize Any Hazard(s)?

2

YesYes

No employer shall permit a worker to work in such proximity to any part of an electric power circuit that the worker could contact the electric power circuit in the course of work

3

Recognize Any Hazard(s)?Recognize Any Hazard(s)?

4

YesYes

Crossing electrical line Crossing electrical line must be supported, must be supported, protected or removed to protected or removed to safeguard workerssafeguard workers

5

Recognize Any Hazard(s)?Recognize Any Hazard(s)?

6

YesYes

Spliced electrical extension cords. Extension cords should be marked DO NOT USE. Also, bad housekeeping, trip hazard and unprotected hole in photograph

7

Recognize Any Hazard(s)?Recognize Any Hazard(s)?

8

YESYES

1. No GFCI2. System not grounded3. Openings where conductors entered not closed4. No cover on boxes 5. Panel boards were not dead front

9

Recognize Any Hazard(s)?Recognize Any Hazard(s)?

10

YESYES

Electric drill flexible cord

was spliced to a non-flexible conductor with

damaged insulation

11

Recognize Any Hazard(s)?Recognize Any Hazard(s)?

12

Yes Yes

Scaffold was erected 4 ½ feet from 7.2 kV power lines

13

Recognize Any Hazard(s)?Recognize Any Hazard(s)?

14

YESYESContinuous

path to ground not maintained;

multiple cords used

for fixed equipment

15

Recognize Any Hazard(s)?Recognize Any Hazard(s)?

16

YESYESEmployer was

operating a stand fan without

grounding protection

17

Recognize Any Hazard(s)?Recognize Any Hazard(s)?

18

YesYes

Conductors entering boxes, Conductors entering boxes, cabinets, or fittings shall be cabinets, or fittings shall be protected from abrasion. protected from abrasion. Openings through which Openings through which conductors enter shall be conductors enter shall be effectively closedeffectively closed

19

Recognize Any Hazard(s)?Recognize Any Hazard(s)?

20

YesYes

Flexible cords and cables may pass through doorways

or other pinch points, if protection

is provided to avoid damage