1 2 Preparing the Camera for Use Turning the Camera OnCamera (PENTAX WG-3 GPS / PENTAX WG-3) The...
Transcript of 1 2 Preparing the Camera for Use Turning the Camera OnCamera (PENTAX WG-3 GPS / PENTAX WG-3) The...
2211
MENU
mm/dd/yy 24h
00:00
Cancel
Settings complete
Date Adjustment
Date Format
Date
Time
01/01/2013
MENU Cancel
CityDST
New York
Hometown
OK OK
MENU Cancel
Initial Setting
HometownNew York
Settings complete
English
DSTOFOFFOFF
MENU Cancel
Initial Setting
HometownNew York
Settings complete
English
DSTOFOFFOFF
P
1 4 : 21 4 : 2 51 4 : 2 53838
+ 1 .+ 1 . 0+ 1 . 01 / 2 51 / 2 5 01 / 2 5 0F 3 .F 3 . 5F 3 . 5
DATE
Names of Parts and Display IndicatorsChecking the Contents of the Package
Preparing the Camera for Use Turning the Camera On
In this Quick Guide, the arrow keys to be pressed are indicated as shown on the right.
Check that your camera came complete with the items listed below.
Operating Manual
Utilities Guide for GPS (PENTAX WG-3 GPS only)
Quick Guide (this guide)
Carabiner strap (O-ST134 / O-ST135)
Macro stand (O-MS2)
Power adapter D-PA135 (AC plug adapter D-PL135 attached)
Rechargeable lithium-ionbattery (D-LI92)
USB cable (I-USB7)Software (CD-ROM) S-SW135
Camera (PENTAX WG-3 GPS / PENTAX WG-3)
The PENTAX WG-3 GPS / PENTAX WG-3 is waterproof, dustproof, and shockproof, as shown below, so you can use it in a wide range of outdoor activities.Waterproof/dustproof: JIS grade 8 waterproof and grade 6 dustproof (IP68)Shockproof: Satisfies the PENTAX drop test (2.0 m height onto a 5 cm thick plywood surface) complying with MIL-Standard 810F Method 516.5-Shock testing.* Waterproof performance is not guaranteed if the camera is exposed to impact such as being dropped or hit.* The camera is not guaranteed to be free of trouble or damage under every condition.
Battery Level IndicatorYou can check the battery level by the indicator on the display.
Battery StatusAdequate power remains.Battery is running low.Battery is running very low.Battery is exhausted.The camera turns off after this message appears.
Screen Display (green) (green) (yellow)
(red)[Battery depleted]
Front
Back
Prepare your camera for use before you start using it.
Attach the carabiner strap supplied with the camera as shown in the illustration.
Install the battery and SD Memory Card as shown in the illustration.
Installing the Battery and SD Memory Card
Attaching the Carabiner Strap
* The SD Memory Cards are sold separately.
The inside of the battery compartment is not waterproof. In places where the camera is exposed to water or dirt such as underwater, at the beach, in a kitchen, etc., make sure that the battery cover lock and release latch are firmly locked so that they won't open unexpectedly. Do not open the cover in such places. When removing the battery or card, avoid places where the camera may be exposed to water or dirt, and make sure that the camera, battery, card, and your hands are completely dry.
Thank you for purchasing this PENTAX digital camera.
Shooting modeFlash Mode
Face Detection
Drive ModeFocus Mode
Digital zoom/Intelligent Zoom
Electronic Level
Memory statusBuilt-in memory(without card)SD Memory CardCard is write-protected
Focus frame Date and time
Date imprint setting
Eye-Fi communication status
World Time setting
Shake ReductionAperture
D-Range Setting
Remaining image storage capacity
EV Compensation
Normal Display in Still Picture Capture Mode
:No icon Hometown: Destination
Shutter speed
Battery level
Display IndicatorsFollowing indicators are displayed in Still Picture Capture Mode.
Pressing the Power Button 3
Continue on the reverse side.
12 Press the four-way controller (5) to select [01] (month), [01] (day) or [2013] (year), then use the four-way controller (23) to set the current date.
11 Press the four-way controller (5), then press the four-way controller (3) to move the frame to [Date].
10
Use the four-way controller (45) to choose a city.
5
Press the four-way controller (3) to move the frame to [W Hometown].
Press the four-way controller (5) to select [24h], then use the four-way controller (23) to select [24h] (24-hour display) or [12h] (12-hour display).
Press the four-way controller (3) to move the frame to [DST] (Daylight Saving Time).
6
Use the four-way controller (45) to select O or P and press the 4 button.The [Initial Setting] screen reappears.
7
Press the four-way controller (3) to select [Settings complete] and press the 4 button.The [Date Adjustment] screen appears.
8
Press the four-way controller (5). The [W Hometown] screen appears.
4
13 Press the four-way controller (5), then press the four-way controller (3) to move the frame to [Time].
14 Set the time in the same manner as in .
15
12
Making the Initial Settings
2
Use the four-way controller (2345) to select the desired language.
The camera turns on and is ready to take still pictures. Press the power button again to turn the camera off.
MemoIf you accidentally select the wrong language and press the 4 button, press the four-way controller (5), use the four-way controller (2345) to select the desired language, and then press the 4 button. The [Initial Setting] screen appears in the selected language.
1
The [Language/ ] screen appears when the camera is turned on for the first time. Select the desired language and then set the date and time.
Press the 4 button. The [Initial Setting] screen appears.
Press the four-way controller (3) to select [Settings complete] and press the 4 button.
9 Press the four-way controller (5) to select [mm/dd/yy], then use the four-way controller (23) to choose the date format.
Formatting an SD Memory CardUse this camera to format (initialize) an SD Memory Card that is unused or has been previously used on other cameras or digital devices. Be aware that formatting deletes all the data stored in the SD Memory Card. On how to format an SD Memory Card, refer to the Operating Manual (p.168).
0 4 / 0 4 / ' 1 30 4 / 0 4 / ' 1 3
CancelMENU
mm/dd/yy 24h
00:00Settings complete
Date Adjustment
Date Format
Date
Time
01/01/2013
Flash
Sub-display
MicrophonesRemote control receiver
Remote control receiver
LED Macro lightsStrap lug
Shutterrelease button Self-timer lamp/
Focus assist light
Power button/Power lamp (green)
Display
Battery cover lock
Battery cover
Release latch
HDMI terminal
USB/AV terminal
Battery lock lever
Tripod socketSpeakers
Lens
(PENTAX WG-3 GPS only)
Battery cover lockRelease latch
SD Memory CardBattery
Battery lock lever
Battery coverSD Memory Card socket
2
3
54
2
3
54
2013/01/18 15:01:06 Illustrator 15.0.2 KB543_544_QG_EN_Omote_CS5e.eps
33
Printed in Indonesia R01BAA1354761
Selecting a Playback Mode44 Playing Back Images
Taking Pictures
Selecting the Flash ModeEach time you press the four-way controller (4), the flash mode switches between the following modes.
Auto
Flash Off
Flash On
Auto + Red-eye
Flash On + Red-eye
Selecting the Drive ModeEach time you press the four-way controller (2), the drive mode switchesbetween the following modes.
Standard (single-frame)
Self-timer (10 sec.)
Remote Control (3 sec.)
Press the shutter release button halfway.The focus frame on the display turns green when thesubject is in focus.
The picture is taken.
Aim the camera at the subject, then press the shut-ter release button. The flash discharges automati-cally depending on the brightness.
Frame the subject using the focus frame on the display.
Press the W / T button to change the captured area.
You can choose the playback mode you want to use from the Playback Mode Palette.
For details about how to use the PENTAX WG-3 GPS / PENTAX WG-3 or instructions on connecting the camera to a computer, refer to the manual below.
Selecting a Shooting Mode
An explanation appears when you select a shooting mode.
Use the four-way controller (2345) to choose a shooting mode, then press the 4 button.
You can choose the optimal shooting mode for your particular situation from the Capture Mode Palette.
Press the four-way controller (3).
Use the four-way controller (2345) to choose a playback mode, then press the 4 button.
3
2
1
4
Memo
Memo
Memo
Memo
Memo
Selecting the Focus ModeEach time you press the four-way controller ( ), the focus mode switches between the following modes.
Standard
Macro
1cm Macro
Pan Focus
Infinity
Manual Focus
The available modes differ depending on the selected shooting mode.You can select Z (2-sec. Self-timer) by pressing the four-way controller (3) and then (5) after selecting g.You can select h (0-sec Remote Control) by pressing the four-way controller (3) and then (5) after selecting i.For details, refer to the Operating Manual (p.74 - 78).
The available modes differ depending on the selected shooting mode, focus mode and drive mode.For details, refer to the Operating Manual (p.84).
Press the four-way controller (3) while an image is displayed in playback mode.
An explanation appears when you select a playback mode.
Widens the area that is captured by the camera.
Enlarges the subject.
Press the shutter release button fully.
PENTAX WG-3 GPS / PENTAX WG-3Operating Manual
The monitor display in 4:3 aspect ratioWhen [Recorded Pixels] is set to /6/f/h/l/m in [A Rec. Mode], the aspect ratio of the image is 4:3 and the monitor display for image capture and playback is as shown below.For details on how to select the number of recorded pixels, refer to the Operating Manual (p.90).
The available modes differ depending on the selected shooting mode.For details, refer to the Operating Manual (p.85).
PENTAX RICOH IMAGING CO., LTD.http://www.pentax.jp
PENTAX RICOH IMAGING FRANCE S.A.S. (European Headquarters) HQ http://www.pentax.eu France http://www.pentax.fr
PENTAX RICOH IMAGING DEUTSCHLAND GmbHhttp://www.pentax.de
PENTAX RICOH IMAGING UK LTD.http://www.pentax.co.uk
PENTAX RICOH IMAGING AMERICAS CORPORATION
http://www.pentaximaging.com
PENTAX RICOH IMAGING CANADA INC.http://www.pentax.ca
PENTAX RICOH IMAGING CHINA CO., LTD.http://www.pentax.com.cn
OKMENU
1 /2
For cont inuously p lay ingback images. Screen orsound ef fects can be set
OKCancel
Slideshow10100-0030038100-0038
EditEditEdit 14:2514:2504/04/'1304/04/'13 14:2504/04/'13
3 83 8
P
The confirmation screen appears.
Play back the image you want to delete.
Press thei button.2
1
Use the four-way controller (2 ) to select [Delete].3
Press the 4 button.4
MemoYou can delete multiple images selected from the 6- or 12-image display. For details, refer to the Operating Manual (p.138).You can delete all images at once. For details, refer to the Operating Manual (p.139).You can protect stored images from being accidentally deleted. For details, refer to the Operating Manual (p.140).
You can play back the captured images on the display.
Playing Back Images
The image appears on the display.Press the Q button after shooting.
Deleting a Single ImageYou can delete a single image currently displayed on the display.
Deleting Images
1
To play back the previous or next image, press the four-way controller (45).Pressing f button during playback displays 6 thumbnail images. Pressing f again in 6-image display switches to 12-image display. Pressing f yet again switches to folder or calendar display. For details, refer to the Operating Manual (p.128).
Memo
10100-0010017100-0017
OKOK
DeleteCancel
OKOKOK
W T
F 4 .F 4 . 6F 4 . 61 / 2 51 / 2 5 01 / 2 5 0
3 83 8
Landscape
For capturing landscapeviews. Enhances colorsof sky and foliage
OK OKMENU Cancel
1 /2
2013/01/18 15:06:43 Illustrator 15.0.2 KB543_544_QG_EN_Ura_CS5e.eps
Digital Camera
Operating Manual
To ensure the best performanc e from your camera, please read the Operating Manual before using the camera.