07A – Multi-Tank Calibration

Apollo System 7A-1

1. Divert hydraulic Flow from Fan

2. Adjust product diverters to Calibration setting

3. Insert the Calibration deflector.

4. Slide sample collection tray onto collector.

5. Adjust the transmissions by moving the locking pin from Direct Drive to Slow Speed Drive.

(DIRECT DRIVE SHOWN) ENSURE THE TRACTOR IS NOT RUNNING WHILE REMOVING PINS!

07A – Multi-Tank Calibration

7A-2 Apollo System

6. Press the Topcon logo for one second to load the Global Home screen menu.

7. Navigate to the Calibration page.

TAP QUICKLY TO

LOAD SCREENS

07A – Multi-Tank Calibration

Apollo System 7A-3

8. Follow the above step in sequence.

1. ENABLE MANUAL

SPEED (GREEN)

2. SET YOUR DESIRED

SPEED

3. Use Arrows to Select

Tank to be calibrated.

4. SELECT GEAR RATIO:

2 (DIRECT) or 16 (SLOW)

5. Press Multi-Tank

Calibration to Start the

Wizard.

07A – Multi-Tank Calibration

7A-4 Apollo System

9. Select Automatic Calibration.

10. Follow the Prompt on the Calibration Wizard. Press the Yellow forward arrow.

07A – Multi-Tank Calibration

Apollo System 7A-5

11. Check the target rates are set correctly.

12. Turn on the Tanks you wish to calibrate by using the Number 1-2-3-4 on the Keypad. The color will

change From Red (Off) to Orange (Ready State).

07A – Multi-Tank Calibration

7A-6 Apollo System

13. Activate the metering by pressing the RUN/STOP button. The metering will then engage and

distribute the product into the sample collector trays.

14. The Estimated Weight will count continuously as product is collected into the Sample Collector.

Keep an eye on the collector boxes, fill until roughly ¾ full.

Keep all hands and personal

clear from the metering

systems, remember multiple

tanks are now live and are

ready to engage.

07A – Multi-Tank Calibration

Apollo System 7A-7

15. When the sample trays are nearly Full Press the Number keys 1-2-3-4 to stop the Tanks from

metering any additional product. When All Tanks are finished Press the RUN/STOP button.

NOTE: You may stop any tank early by simply pressing the Number Key.

Notice how the Tank LED status is RED = OFF

16. Remove the Collector Trays and Weigh the Product using the provided scale.

22.70 lbs.

07A – Multi-Tank Calibration

7A-8 Apollo System

17. Write down Tank scale weights and return to the tractor cab.

18. Return to the monitor, Press Next to Proceed.

07A – Multi-Tank Calibration

Apollo System 7A-9

19. Notice the estimated weights. Now Enter the Actual recorded weight in the weight windows.

20. Proceed by pressing the Next icon.

Press here to enter the

weights from the scale

07A – Multi-Tank Calibration

7A-10 Apollo System

21. Press the Green Saved Icon and then the Green Accept Check mark to save the Calibration factor.

22. It is recommends to repeat the Calibration procedure 2-3 additional times to fine tune and verify

the calibration factors are accurate.

Confirm the Cal factor by

pressing the Accept Icon.

07A – Multi-Tank Calibration

Apollo System 7A-11

NOTES: