Post on 02-Jan-2016
17KDL-40V4100/40V4150
KDL-40V4100/40V4150
1
2
LCD Panel
Balancer (ETC- Inverter MT) Board
Balancer (ETC- Inverter MT) Board
Inverter Board Cover
WARNING
NEVER REMOVE THE SCREWS SECURING THE PLASTIC STRIP HOLDING
THE LAMP SOCKETSDAMAGE TO THE
BACKLIGHT TUBES WILL
!
OCCUR!
1-9. BALANCER (ETC- INVERTER MT) BOARD REMOVAL
1 Remove 8 screws 2 Pull out the Board from the Lamp Socket
SHIELD REMOVALBALANCER (ETC-INVERTER) BOARD REMOVAL
WARNING
NEVER REMOVE THE SCREWS SECURING THE PLASTIC STRIP HOLDING
THE LAMP SOCKETSDAMAGE TO THE
BACKLIGHT TUBES WILL
Only remove the screws securing the inverter cover which may be metal or plastic. The remaining plastic strip contains sockets for the fluorescent backlights and should never be loosened. The backlights will pop out of the sockets and/or break the backlight requiring a LCD panel replacement.
REMOVE SCREWS SECURING
SHIELD
REMOVE CONNECTORS AND
PULL BOARD TO THE RIGHT
!
.
OCCUR!
BACKLIGHTEND VIEW
SOCKET
NOTE: The LVDS cable can only be installed one way. There is colored tape on the cable to determine which side is attached to the TCON and which side is attached to the BU Board. Refer to Wire Dressing Illustration Installation Procedure on Page 33.
18KDL-40V4100/40V4150
KDL-40V4100/40V4150
1 Slide out Speaker (R) unit from Bezel2 Slide out Speaker (L) unit from Bezel3 Remove 2 screws from Under Bar4 Disconnect 1 connector and Slide out H3E Board from Clear Panel5 Release hooks and remove from Bezel6 Remove 1 screw and Release hooks from Clear Panel7 Disconnect 1 connector and Slide out H4 Board from Light Guide
1-10. SPEAKERS, UNDER BAR, H3E BOARD, H4 BOARD, AND LIGHT GUIDE REMOVAL
Speaker Unit (L)
Speaker Unit (R)
Light Guide
Under Bar
H3E Board
H4 Board
Clear Panel
2
3
1
5
4
6
7
19
KDL-40V4100/40V4150
KDL-40V4100/40V4150
H Board/Speaker Harness
Apply harness to Panel TOP edge. To center Harness, positionRED UL tape over center of panel. Use screw on panel asReference where center of panel is. Apply Sheet core C overRed UL tape once harness is centered. Apply Sheet Core Cover Black UL Tape on Harness (guides).
Center of panel
1
3 2
WIRE DRESSING
LEGEND
SHEET CORE C (2-688-011-01)QTY=9
LCD TAPE (2-688-062-01)QTY=6
SLIDE CLAMP (2-650-770-11)QTY=6
20
KDL-40V4100/40V4150
KDL-40V4100/40V4150
LEGEND
SHEET CORE C (2-688-011-01)QTY=9
LCD TAPE (2-688-062-01)QTY=6
SLIDE CLAMP (2-650-770-11)QTY=6
Combination H Board/Speaker Harness
Apply Sheet Core C to Harness. Use BLACK UL TAPE on Harness as guide where to apply Sheet Core C. Apply LCD Tape over speaker wires. Use Black UL tape as guide where to apply tape. DO NOT apply LCD tape over hole in speaker!
4
1