Post on 28-Sep-2020
A = Inlet SizeB = Outlet Size K = 5 1/4" V = (A/2x1.414)+((C+2)/2)+6C = Branch Size L = Length W = (C+2)x1.414 + 4D = Branch Size O = Offsetting Amount X = A - B (with 4" minimum)H = 3" if C = 3" to 8" R = 1.5 x A Y = (1.414xC) + 4 6" if C = 9" to 16" S = 2 Z = C + H + 4 9" if C = 17" to 24" T = A/4 + 2 * = Consult Factory 12" if C = 25" & Up U = Ax2 + 2
SP PP FF
B1 EP EC
SE45 SE90 EV90
ET90
Spiral Pipe Pipe-to-Pipe Coupling Fitting-to-Fitting Coupling
Bellmouth End Plug End Cap
Stamped Elbows Mitered Elbow
Elbow w/Tap2 Gore Elbows
E1 Thru E36
Single Wall Round Spiral Pipe and Fitting Standards
Dimensions
Spiral Pipe of TexasFt. Worth, TX ph: 817.877.3543
spotUSA.comrev. 08/17
SET
SQR
LT T1 T1R
LL L1 L1R
LCT CT1 CT1R
3 Gore Elbows Offset
E37 Thru E71
E72 Thru E90
Single Wall Round Spiral Pipe and Fitting Standards
5 Gore Elbows Square-To-Round
Straight 90 Degree Tees
45 Degree Laterals
Conical 90 Degree Tees
Spiral Pipe of TexasFt. Worth, TX ph: 817.877.3543
spotUSA.comrev. 08/17
LLL LL1 LL1R
LCL CL1 CL1R
R1 ER1 Y2
Y2R BT BTR
Project: Approval:
Location:
System:
Contractor:
Engineer:
Single Wall Round Spiral Pipe and Fitting Standards
Bullhead Tee Reducing Bullhead Tee
Conical 45 Degree Lateral Tees
Low Loss 90 Degree Tees
Reducing "Y" Fitting
Reducers "Y" Fitting
Spiral Pipe of TexasFt. Worth, TX ph: 817.877.3543
spotUSA.comrev. 08/17