Post on 04-Aug-2020
1
Lecture 7
Semiconductor Device Physics
http://zitompul.wordpress.com
2 0 1 3
2
Chapter 6pn Junction Diodes: I-V Characteristics
Semiconductor Device Physics
3
Majority
carriers
Majority
carriers
Qualitative Derivation
Chapter 6 pn Junction Diodes: I-V Characteristics
4
Current Flow in a pn Junction Diode
Chapter 6 pn Junction Diodes: I-V Characteristics
When a forward bias (VA > 0) is applied, the potential barrier to diffusion across the junction is reduced.
Minority carriers are “injected” into the quasi-neutral regions Δnp > 0, Δpn > 0.
Minority carriers diffuse in the quasi-neutral regions, recombining with majority carriers.
5
Ideal Diode: Assumptions
Chapter 6 pn Junction Diodes: I-V Characteristics
Steady-state conditions.
Non-degenerately doped step junction.
One-dimensional diode.
Low-level injection conditions prevail in the quasi-neutral regions.
No processes other than drift, diffusion, and thermal R–G take place inside the diode.
6
N n N n N
( )( )
dn d nx q n qD q n qD
dx dx
J E E
P p P p P
( )( )
dp d px q p qD q p qD
dx dx
J E E
Current Flow in a pn Junction Diode
Chapter 6 pn Junction Diodes: I-V Characteristics
Current density J = JN(x) + JP(x)
JN(x) and JP(x) may vary with position, but J is constant throughout the diode.
Yet an additional assumption is now made, that thermal recombination-generation is negligible throughout the depletion region JN and JP are therefore determined to be constants independent of position inside the depletion region.
7
n-sidep-side
p0 p A
2
ip0 p
A
( )
( )
p x N
nn x
N
n0 n D
2
in0 n
D
( )
( )
n x N
np x
N
p p A( )p x N n n D( )n x N
Carrier Concentrations at –xp, +xn
Chapter 6 pn Junction Diodes: I-V Characteristics
Consider the equilibrium carrier concentrations at VA = 0:
If low-level injection conditions prevail in the quasi-neutral
regions when VA 0, then:
8
i P
N i
( )
i( )
i
E F kT
F E kT
p n e
n n e
A2
i qV kTnp n e
N ii P
N P
( )( )2
i
( )2
i
F E kTE F kT
F F kT
np n e e
n e
p nfor x x x
“Law of the Junction”
Chapter 6 pn Junction Diodes: I-V Characteristics
The voltage VA applied to a pn junction falls mostly across the depletion region (assuming that low-level injection conditions prevail in the quasi-neutral regions).
Two quasi-Fermi levels is drawn in the depletion region:
9
p p A( )p x N
n-sidep-side
n n D( )n x N
A
2
ip p
A
( ) ( 1)qV kTn
n x eN
A
2
in n
D
( ) ( 1)qV kTn
p x eN
Excess Carrier Concentrations at –xp, xn
Chapter 6 pn Junction Diodes: I-V Characteristics
A
A
2
ip p
A
p0
( )
qV kT
qV kT
n en x
N
n e
A
A
2
in n
D
n0
( )
qV kT
qV kT
n ep x
N
p e
10
A 0.6 0.02586 12 3
p p p0( ) 100 1.192 10 cmqV kTn x n e e
12 12 3
p p p p p0( ) ( ) 1.192 10 100 1.192 10 cmn x n x n
Example: Carrier Injection
Chapter 6 pn Junction Diodes: I-V Characteristics
A pn junction has NA=1018 cm–3 and ND=1016 cm–3. The applied voltage is 0.6 V.
a) What are the minority carrier concentrations at the depletion-region edges?
b) What are the excess minority carrier concentrations?
A 4 0.6 0.02586 14 3
n n n0( ) 10 1.192 10 cmqV kTp x p e e
14 4 14 3
n n n n n0( ) ( ) 1.192 10 10 1.192 10 cmp x p x p
11
A
n n n0( ) ( 1)qV kTp x p e
2
n nP 2
p
0 , 0d p p
D xdx
P P
n 1 2( )x L x L
p x Ae A e
0x 0 x
P P pL D
Excess Carrier Distribution
for 0x
Chapter 6 pn Junction Diodes: I-V Characteristics
From the minority carrierdiffusion equation,
We have the following boundary conditions:
n ( ) 0p
For simplicity, we develop a new coordinate system:
Then, the solution is given by:
• LP : hole minority carrier diffusion length
12
Excess Carrier Distribution
A
n n0( 0) ( 1)qV kT
p x p e
n ( ) 0p x
A P
n n0( ) ( 1) , 0qV kT x L
p x p e e x
P P'/ '/
n 1 2( )x L x L
p x Ae A e
NA
p p0( ) ( 1) , 0x LqV kTn x n e e x
A /
1 n0( 1)qV kTA p e
2 0A
Chapter 6 pn Junction Diodes: I-V Characteristics
New boundary conditions
From the x’ → ∞,
From the x’ → 0,
Therefore
Similarly,
13
A Pn PP P n0
P
( )( ) ( 1)
qV kT x Ld p x Dx qD q p e e
dx L
J
NAp N
N N p0
N
( )( ) ( 1)
x LqV kTd n x D
x qD q n e edx L
J
n-side
p-side
p nN P N P0 0x x x x x x
J J J J J
A2 N Pi
N A P D
( 1)qV kTD D
qn eL N L N
J
pn Diode I–V Characteristic
Chapter 6 pn Junction Diodes: I-V Characteristics
14
A
0
2 N P0 i
N A P D
( 1)qV kTI I e
D DI Aqn
L N L N
I A J
pn Diode I–V Characteristic
Chapter 6 pn Junction Diodes: I-V Characteristics
A2 N Pi
N A P D
( 1)qV kTD D
Aqn eL N L N
• Shockley Equation,for ideal diode
• I0 can be viewed as the drift current due to minority carriers generated within the diffusion lengths of the depletion region
15
I0 can vary by orders of magnitude, depending on the semiconductor material, due to ni
2 factor.
In an asymmetrically doped pn junction, the term associated with the more heavily doped side is negligible.
If the p side is much more heavily doped,
If the n side is much more heavily doped,
2 NP0 i
P D N A
DDI Aqn
L N L N
2 P0 i
P D
DI Aqn
L N
2 N0 i
N A
DI Aqn
L N
Diode Saturation Current I0
Chapter 6 pn Junction Diodes: I-V Characteristics
16
N P J J J
Diode Carrier Currents
N p n N p
P p n P n
( ) ( )
( ) ( )
x x x x
x x x x
J J
J J
Chapter 6 pn Junction Diodes: I-V Characteristics
• Total current density is constant inside the diode
• Negligible thermal R-G throughout depletion region dJN/dx = dJP/dx = 0
17
n0p
p0p
p0n
n0n
Carrier Concentration: Forward Bias
A2
i qV kTnp n e
p A
n D
p N
n N
Excess minoritycarriers
Excess minoritycarriersA P
n n0( ) ( 1)qV kT x L
p x p e e NA
p p0( ) ( 1)x LqV kTn x n e e
Chapter 6 pn Junction Diodes: I-V Characteristics
Law of the Junction
Low level injection conditions
18
Carrier Concentration: Reverse Bias
Chapter 6 pn Junction Diodes: I-V Characteristics
Deficit of minority carriers near the depletion region.
Depletion region acts like a “sink”, draining carriers from the adjacent quasineutral regions
21
2
S CR A DBR bi
A D2
N NV V
q N N
E
A DCR bi BR
S A D
2 N NqV V
N N
E
• At breakdown, VA=–VBR
Breakdown Voltage, VBR
Chapter 6 pn Junction Diodes: I-V Characteristics
If the reverse bias voltage (–VA) is so large that the peak electric field exceeds a critical value ECR, then the junction will “break down” and large reverse current will flow.
Thus, the reverse bias at which breakdown occurs is
22
2 A DCR BR
S A D
2 N NqV
N N
E
Small E-field:
High E-field:
Low energy, causing lattice vibration and localized heating only
High energy, enabling impact ionization which causing avalanche, at doping level N < 1018 cm–3
Breakdown Mechanism: Avalanching
Chapter 6 pn Junction Diodes: I-V Characteristics
• ECR : critical electric field in the depletion region
2
CRBR
2
sVqN
23
Breakdown Mechanism: Zener Process
Chapter 6 pn Junction Diodes: I-V Characteristics
Zener process is the tunnelingmechanism in a reverse-biased diode.
Energy barrier is higher than the kinetic energy of the particle.
The particle energy remains constant during the tunneling process.
Barrier must be thin dominant breakdown mechanism when both junction sides are heavily doped.
Typically, Zener process dominates when VBR < 4.5V in Si at 300K and N > 1018 cm–3.
24
Chapter 7pn Junction Diodes: Small-Signal Admittance
Semiconductor Device Physics
25
V0 << VA
RS : serial resistanceC : capacitanceG : conductanceY : admittance
Small-Signal Diode Biasing
Chapter 7 pn Junction Diodes: Small-Signal Admittance
When reversed-biased, a pn junction diode becomes functionally equivalent to a capacitor, whose capacitance decreases as the reverse bias increases.
Biasing additional a.c. signal va can be viewed as a small oscillation of the depletion width about the steady state value.
Y G j C
26
DCD
IC
kT q
sJC A
W
Junction / depletion capacitance,
due to variation of depletion charges
i
J DC C C av
1R G
Diffusion capacitance,
due to variation of stored minority charges in the quasineutral regions
Minority carrier lifetime
Total pn Junction Capacitance
Chapter 7 pn Junction Diodes: Small-Signal Admittance
• CJ dominates at low forward biases, reverse biases.• CD dominates at moderate to high forward biases.
27
2
bi A2 2 2 2
J s B S
1 2( )
WV V
C A qN A
Relation Between CJ and VA
sbi A
B
2W V V
qN
NB : bulk semiconductor doping,
NA or ND as appropriate.
Chapter 7 pn Junction Diodes: Small-Signal Admittance
For asymmetrical step junction,
Therefore,
• A plot of 1/CJ2 versus VA is linear.
• The slope is inversely proportional to NB.• An extrapolated 1/CJ
2 = 0 intercept is equal to Vbi.