Post on 21-Jul-2016
description
RICi-E1, RICi-T1Intelligent Converters for Fast Ethernet over E1/T1 Product Update & Overview (Version 2.10)
Ethernet Access over PDH/SONET/SDH SolutionsUpdated: July 2007
master.ppt Slide 2
What's new in the product?
master.ppt Slide 3
Version 2.10
• Generic Frame Procedure (GFP- G.8040)• New HW:
• Physical E1/T1 port changed to comply with RAD’s products RICi-4/8E1/T1 and Egate-20 (swap of RX & TX lines in respect to the old HW)
• Flow control support at 100MHz
master.ppt Slide 4
Generic Frame Procedure (GFP) Advantages
• Byte by byte transmission (unlike IMA & MLPPP): • Reduced latency, for time-sensitive services
• Fixed overhead (unlike HDLC):• Improved line utilization• predictable throughput regardless of data transmitted
• Reduced packet re-transmission due to errors • Frame delineation and synchronization mechanism based on GFP HEC field and not
HDLC flag• Error detection and correction (single & multiple)
• Robust protocol includes:• CRC for GFP packet header field• CRC for payload
• Standard protocol• Allow interoperability between different vendors
master.ppt Slide 5
Ordering option
• RICI-E1 replaces RICI-E1/AC & RICI-E1/48• RICI-E1/U replaces RICI-E1/AC/U & RICI-E1/48/U• RICI-T1 replaces RICI-T1/AC & RICI-T1/48• New option Hardened enclosure, resistant to extreme
temperatures (-22C to 70C/7.6° to 158°F) with 24 VDC power supply• RICI-E1/24• RICI-T1/24/U• RICI-T1/24
master.ppt Slide 6
ApplicationsApplications
master.ppt Slide 7
Demarcation Point between the Carrier’s and Customer’s Networks
• RICi-E1/T1 enables service providers and ISPs to supply transparent Ethernet services, without interfering with user traffic
master.ppt Slide 8
Main Value Proposition
• Supports Generic Frame Protocol (GFP-G.8040):• Allows connectivity with third party device• Improves PDH link utilization
• Enables provision of transparent LAN services • Secured user and management traffic• Full utilization of E1 or T1 circuit by Ethernet traffic
master.ppt Slide 9
RICi-E1/T1 RICi-E1/T1 General OverviewGeneral Overview
master.ppt Slide 10
General
• RICi-E1/T1 is an Ethernet CLE (Customer-Located Equipment)
• Provides a demarcation point between the private LAN and the operator’s network
• Intelligent converter between Ethernet to E1 or T1
• Bridges between a LAN interface and framed/unframed E1 or T1 interface
master.ppt Slide 11
Physical
• Network interfaces: • E1 balanced RJ-45• E1 unbalanced BNC• T1 balanced RJ-45
• User interface:• 10/100 BaseT (RJ-45)• Half or full duplex.• Auto negotiation
• DB-9 for local management• Power Supply:
• Wide range power supply 100–240 VAC or -48/60 VDC • 24 VDC for hardened option
• 1U half 19 inch box
master.ppt Slide 12
Management
• VLAN separation of management and user traffic:• All packets with dedicated management VLAN will only
be sent to the network port• In-band management :
• Via the Ethernet port:– Telnet– ConfiguRAD– RADview‑Lite (SNMP)
• Out-of-Band management:• ASCII terminal connected to control port
master.ppt Slide 13
Bridge capabilities
• Ethernet Bridge• Transparent/Filter mode:
• MAC Learning and filtering is enabled/disabled• QoS:
• four priorities according to:– VLAN priority bits (802.1p)– IP Precedence field
• Enable/disable VLAN stacking (“double VLAN”)
Thank you for your attention